What are the Symptoms of ignition coil failure?
June 22, 2009 10:59PM
Generally 1 or more cylinders won't fire. This could mean that the vehicle won't start, it could also make the vehicle act underpowered and vibrate.
Asked in Toyota Land Cruiser, Symptoms
What are the symptoms of ignition coil failure in a Toyota land cruiser?
Asked in American Cars
Where is the ignition failure sensor in a 01 stratus rt?
Asked in Jeep Cherokee
1996 Jeep Cherokee that turns over but will not start no spark to the distributor or the spark plugs replaced the ignition coil and the pick-up coil in the distributor Engine is getting fuel?
Asked in Range Rover
You have no spark on your 1993 Range Rover 3.9L what is the most common part for failure?
What are symptoms of a ignition coil?
What are signs and symptoms of a bad ignition coil on 1992 Chevy astro?
Where is the ignition coil on a 96 civic cx hatchback?
Asked in Car Electronics and Lights
How can you tell if an ignition coil needs to be replaced?
Asked in Auto Parts and Repairs
Is an ignition module the same as a ignition coil?
Asked in Car Stalling Problems, Ford Expedition
Can a bad catalytic converter damage the ignition coils or a bad ignition coil can cause to catalytic to go bad on a ford expedition?
Asked in Dodge Dakota
What do engine codes 12 43 and 55 mean for 1996 Dodge Dakota with 3.9L engine?
How do you replace ignition coil on 1999 Mercury Grand Marquis?
Asked in Cars & Vehicles, Toyota Tercel
Where is the ignition coil located in a 1998 tercel?
How do you change the ignition coil on a 2006 mustang?
V6 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil * Disconnect the spark plug wires from the ignition coil * Remove the ignition coil mounting bolts and remove the coil from the valve cover V8 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil if youre going to remove more then one ignition coil mark each electrical connector with its corresponding coil to prevent mix-ups during reassembly * Remove the ignition coil hold-down bolt * Grasp the ignition coil firmly and pull it straight up
Asked in Chevy Express
How do you replace a coil on 2003 Chevrolet Express?
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
What are symptoms of faulty ignition coil?
Symptoms of a faulty ignition coil are power to the coil checked with a multi-meter and no power out checked by pulling any of the spark plugs, placing it back int the spark plug cap, grounding out the end of the spark plug against metal while you have someone turn the motor over lack of spark would indicate no power from coil. You can also check the output side of the coil with a multimeter but note that your reading will jump instead of staying constant.
Asked in Cars & Vehicles, Asian Cars, Toyota
I have replaced everything involved in my ignition system but still lose spark after driving for a short period of time if you le tit sit for an hour it will restart again any suggestions?
did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity. did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity.