Want this question answered?
If you connect to the router via the console port then you are physically making a connection with a physical cable to the router. This implies you have to be close to the router itself. Using telnet allows you to connect to the router from anywhere in the network, and doesn't require a physical cable connection.
The network administor must have physical access to the device to establish a console connection whereas TELNET access can be established form a remote location. However telnet access depend upon a router with network access's, whereas a console connection can be used to access the router regardless of the router's configuration.
I don't believe so. It will depend on your connection. If your connection is not how you would like it move the router closer to your console, or vice-versa.
rollover cable
make a connection from the router's console port to your laptop's serial port and configure the router from your laptop.
For a wired connection you need a high speed modem. For a wireless connection you need a wireless networking adapter for your 360. Or perhaps you need a new router, as some are incompatible with the 360 console.
The default speed is 9600.
One of the advantages of purchasing a wireless router from BT is that it will also allow you to connect to BT hotspots, meaning that if there was ever a problem with your router, you could still connect to a hotspot, and would not lose internet connection between when the router failed and when the repair could be done.
Remove Console password router>enable router#configure terminal router(config)#line console 0 router(config-line)#no login router(config-line)#no password router(config-line)#exit router(config)#exit
Rollover cable (also known as Cisco console cableor a Yost cable) is a type of null-modem cable that is often used to connect a computer terminal to a router's console port
To connect to a cisco 1800 series router, you need either a network connection that goes to the router, and then you would configure the router to allow telnet or you would need a console cable, also called a rollover or cisco cable and physical access to the device.
You can use a wireless connection if you have a wireless router