Want this question answered?
A tube connector is the standard fitting that goes on a tube or hose. A tube adapter fits to a tube or hose and enables it to connect to a fitting of a different size to its standard.
There is a fitting on the outside of your camper or a fill tube. Just put a gardenhose on the fitting for a hose or open the fill tube and pore in water.
pretty sure its in the condensor, it will always be at a fitting that has a steel line that has a crimp mark about three inches from fitting to keep tube in place
Most GM's put the orfice tube in the output side of the condenser, near the bottom. Locate the fitting that runs from the condenser to the firewall, open that fitting and the orfice tube should be inside.
V55.3
wiring diagram of electronic choke in tube light
It matters if it has ac or not. If it is a non ac vehicle, the hoses and coolant flow from the fitting close to the thermostat housing to the lower heater core tube, then out the upper heater core tube to the fitting on the water pump. If it has ac, the hose from the upper heater core tube connects to the fitting on the radiator.
Who has a reputation for making good fitting dentures?
Description for NSN 4730012187746 is: FERRULE,BRAZING,TUBE FITTING.
It is located in the line between the High side service port and the evaporator in front of the alternator. It's hidden under the foam pipe insulation. Taurus/Sable Liquid Line and Orifice Tube The orifice tubes on 2000 to 2007 Ford Taurus and 2000 to 2005 Mercury Sable can be changed. At first glance, the liquid line looks like one long hose. But unlike the liquid lines of the '80s and '90s, this hose has a fitting in the middle. The orifice tube is located at this fitting. To replace the orifice tube, remove the washer and overflow bottle. The high side service port is on a pipe about eight inches long to make it easier for service. The fitting and orifice tube are near this pipe. The fitting is covered with a protective rubber cover. The cover makes it hard to see the fitting and that the orifice tube is replaceable. Push the cover back. Disconnect the fitting. Replace the orifice tube. Lubricate the new o-ring (# 24608), and torque the fitting to 18 lb-ft.
92311prescription of optical and physical characteristics of and fitting of contact lens, with medical supervision of adaptation; corneal lens for aphakia, 1 eye92312 prescription of optical and physical characteristics of and fitting of contact lens, with medical supervision of adaptation; corneal lens for aphakia, both eyes92313 prescription of optical and physical characteristics of and fitting of contact lens, with medical supervision of adaptation; corneoscleral lens
A drawtube is a tube fitting coaxially within another tube through which it can slide. It is used in telescopes, microscopes and other devices. In the microscope it is the cylindrical structure which is used to support the eyepiece.