6 1-2 in the door 6 6 1-2 in the door 6 1-2 to 6 3-4 in the back deck
the fusebox ona 1999 chevyprizm is to the right of the radiator under the hood
The alternator blocks access to it. You need to remove the serpentine belt, then the alternator to get to the thermostat.
Go to an auto parts house or a bookstore and buy a Haynes Manual.
1996 through 1999 Chevrolet Tahoes normally have 6 1/2" speakers for the rear. edit: Forgot to say, these are shallow mount speakers! So if you are replacing them, do not get woofers or larger-cone speakers as they will not fit.
The stock speakers in a 1999 single cab Chevy Silverado typically measure 6.5 inches in diameter for the front door speakers. The rear speakers, if equipped, are usually 4x6 inches. It's always a good idea to verify the specific configuration, as variations may exist based on the vehicle's audio package.
Crutchfield shows the DOOR speakers to be 5 1/4" and the REAR speakers to be 6" X 8."
Prizm and Corolla were the same car, so yes.
I do not know about the standard system but if you have the optional Monsoon system, the front speakers are already 2-way component and the back speakers are component 6.5 subs.
In a 1999 Chevrolet Prizm, the dash light fuse is typically located in the fuse box under the dashboard on the driver's side. To access it, you may need to remove a cover panel. The specific fuse for the dash lights is usually labeled "Instrument Panel" or something similar; refer to the fuse diagram on the cover for precise identification. Always ensure the vehicle is turned off before checking or replacing fuses.
yup bub its the speakers and u do need new speakers
different models have different layouts , sizes etc but a 99 hatch back has 13cm door speakers and standard 6x9 inch in the rear
To replace the window crank on a 1999 Chevrolet Prizm, first, remove the decorative cover if present by gently prying it off with a flathead screwdriver. Next, use a small socket or ratchet to remove the retaining screw that holds the crank in place. Once the screw is removed, pull the crank straight off the window regulator shaft. Finally, align the new crank with the shaft, secure it with the screw, and replace the cover if applicable.