If your problem with oilpan is the drainscrew or drainbolt there is a Universal replacement that has threads on it similar to a TAP used to make new threads. For most vehicles. If you have a hole in it possibly welded. Otherwise buy a new oilpan. Good Luck.
On the bottom of the oilpanOn the bottom of the oilpan
Where is the Oil Filter on a 2003 Dodge Neon?" The Oil Filter is close to the oilpan on the right side of the car, best way to see it is raise the front of the car.
Drop the oilpan, remove oil pump. Measure oilpan depth, set new pump & sump height. Prime new oilpump, install, replace oilpan
Assemble a new patch and replace the damaged patch with the new patch
1. Be Careful. 2. Remove old oilpan. 3. While you are there replace the oil pump and wire out your oil holes. 4. Replace with new oilpan. The oilpan does not need to be torqued to it's limit - just enough so it doesn't leak. Gasket sealer only makes things worse. If your oilpan is getting pressurized you have other problems. 1. Be Careful. 2. Remove old oilpan. 3. While you are there replace the oil pump and wire out your oil holes. 4. Replace with new oilpan. The oilpan does not need to be torqued to it's limit - just enough so it doesn't leak. Gasket sealer only makes things worse. If your oilpan is getting pressurized you have other problems.
what is 220 NMC? Been in the trade 35 years. never heard of it!
Use a speckling compound or joint compound.
oilpan on any engine is located at the bottom of the engine. it is the most lowest part of an engine, it bolts onto the bottom of the engine block
There is not really any easy to do it. You just have to sit the new gasket around the rim of the oilpan and bolt it back on. Just make sure that the gasket is centered or it will not make a good enough seal. However you could use a small amount of sealent glue or something simalar and stick the gasket into place before putting the pan back on, but only a very small amount or you will create a gap.
The best way to set up bee hives is to level a patch of ground in your backyard, raise the hive boxes on cinder blocks, buy beekeeping materials and put the bees in the hives.
Unbolt it.
On the bottom of the oilpan