Auto Parts and Repairs
Spark Plugs and Wires
Ford Expedition XLT
Chevy Camaro RS

What causes a 1988 Chevy Beretta to have no spark?

373839

Top Answer
User Avatar
Wiki User
Answered
2007-05-11 21:25:10
2007-05-11 21:25:10

Bad coil Distributor cap Rotor

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


the gap is 35 assuming you have the 2.0 4 liter

I am trying to find the 1988 chevy beretta computer module and where is it located?

Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...

The 1988 Beretta can run hot for several reasons. The Coolant could be low, the thermostat stuck, the water pump is bad, or there could be a blown head gasket.

Torque converter lock-up solenoid is bad. Common problem with 1988 Beretta.

what is a 1988 Chevy Beretta 5 speed V-6 with 74,000 miles on in excellent shape worth

you need: fuel compression and spark

The 1988 Chevy Cavalier spark plug wires are quite easy to remove. The spark plug wires simply pull off on each end. Put the new spark light wires on by pushing downward on each end.

i just got my 88 beretta gt 2 days ago and it is great!to answer your question,yes the 88 etta gt does have power windows and locks

depends,check the chart at point of purchase

I won't swear to it, but it should be .045. That is for a 3.1L engine.

The engine needs spark, fuel and compression to run. You have one of those missing.

IT COULD BE A WORN ENGINE MOUNT. TO BE SURE, PUT YOU CAR IN GEAR PRESS THE BRAKE APPLY THE E-BRAKE AND ACCELERATE THE CAR IF YOU FEEL THE SAME SHAKING IS YOUR ENGINE MOUNTS. (BE Careful)

The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.

According to the Chilton Corsica/Beretta 1988-1996 Manual, there are 21 steps to removing the ignition cylinder (and another 15 - 20 to reinstall it). Not that I don't want to past them all here, but you should get a manual... they're handy to have for any repairs.

It should be .045 of an inch. there should be a sticker on the fie wall or under the hood to confirm

Radio suppressors for the alternator etc., and suppressed spark plug leads.

1988 kx 250 not getting good spark now what can i do

NO. 1988 is when chevy changed everything.

Backfire is normally caused by engine out of time, or spark plug wires installed incorrectly.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.