A vehicle's computer will give the mechanic specific codes but usually the underlying problem is obvious to you; for example if you unplug the electrical in seats in most newer cars, it will turn on the airbag light which will send codes to your mechanic when hooked up to their diagnostic equipment. These codes usually allow the mechanic to electronically reset the computer in the vehicle therefore turning off the dashlight, or whatever caused the computer to trip electronically... have you had the mechanic hook your car to the computer? They should know what the code means if they have the right equipment..........Hope this helps, wish you question was more specific. If your car's radio screen reads, CODE, this is usually due to a dead battery and happens the first time you go to turn radio back on......
what causes the knock sensor code on a 2002 Kia Spectra. Thank You sreddish@neo.rr.com
Error code P0505 typically indicates a fault with the idle air control system. This could be due to a faulty idle air control valve, a vacuum leak, or a problem with the throttle body. It is recommended to have the system inspected by a mechanic to diagnose and repair the issue.
Trouble code P0730 means:Incorrect gear ratio
A mutation that causes the code for the wrong amino acid (apexvs.com)
Trouble code P0740 means:Torque converter clutch circuit malfunction
If the check engine light is on, the computer has detected a malfunction and set a code. You will need to have the code scanned to know possible causes.If the check engine light is on, the computer has detected a malfunction and set a code. You will need to have the code scanned to know possible causes.
P0700 is transmission code present. The PCM sets this code when there is a code in the TCM. You will need to have the TCM checked to know it's code and possible causes.
That is a code for a problem in the theft alarm or chipped key system.
Trouble code P0173 means:Fuel trim malfunction (Bank 2)
Trouble code P0173 means: Fuel Trim (Bank 2)
Trouble code P1693 means: A companion DTC was set in both the ECM and PCM
There are several possible causes of a Ford code 1405. Some of the causes could be DPFE sensor harness short, plugged EGR tube, and or a faulty DPFE.