The force exerted by pad footings, known as applied force...in natural fact, there is a shear force present 45deg. to the vertical of the footing. When the shear forces are projected and touch those of another footing placed on the ground, then its referred to as overlapping in which it means that in that area, the soil investigation should be carried out deeper that the usual values vertically below the proposed footings.
Electrical energy absorbed by the lamp's filament produces thermal energy as well as light.
For a series circuit... Each bulb has different impedance (ohms) resulting in a different voltage drop across each. Remember Kirchoff's Current Law: The current at each point in a series circuit is the same. That same current, multiplied by the different voltage drops results in different powers (watts = amps * volts) for each bulb. For a parallel circuit. Again, each bulb still has different impedance. This time, the voltage drop is the same (Kirchoff's Voltage Law) but the current in each bulb is different. Same situation - different power in each bulb.
here's a cogent discussion: http://answers.yahoo.com/question/index?qid=20090215214428AAltCZz
The current flowing through a bulb is equal to the (voltage across the bulb) divided by the (bulb resistance), and can be expressed in Amperes. The rate at which the bulb dissipates energy is equal to (voltage across the bulb) times (current through the bulb), and can be expressed in watts.
The sphygmomanometer is designed to monitor blood pressure by measuring the force of the blood in the heart where the pressure is greatest. This occurs during the contraction of the ventricles, when blood is pumped from the heart to the rest of the body (systolic pressure). The minimal force is also measured. This occurs during the period when the heart is relaxed between beats and pressure is lowest (diastolic pressure).
Shape: The pressure bulb is typically depicted as a three-dimensional shape, often resembling an inverted cone or pyramid. It extends downwards from the base of the loaded area or foundation into the soil. Distribution: Within the pressure bulb, the pressure is not uniformly distributed. It is highest at the base of the loaded area and decreases with depth. The pressure distribution is influenced by factors such as the shape and size of the foundation, the load magnitude, and the properties of the soil. Depth: The depth of the pressure bulb varies depending on the characteristics of the foundation and the soil. Deeper foundations will have deeper pressure bulbs.
The Zone in a loaded soil mass bounded by any arbitrary isobar is known as a pressure bulb. The vertical pressure at any point on the surface of the pressure bulb is the same.
no
Bad bulb, no power, no ground.
A cracked primer bulb. You will need to replace it.
Evaporation causes cooling.
1000 Pa
If you squeeze the bulb to expel most of the air, then release it with the tip under water, the pressure in the bulb drops and external air pressure on the surface of the liquid in its container forces the liquid into the dropper. When you squeeze the bulb again, you increase the pressure and force the liquid out.
The 400W high pressure Sodium bulb contains a silver lining inside the frame to give better reflection of light. However, no silver is found inside the bulb.
no
jrijgreijgeipgoerh/za
by the more amount of electricity the bulb needs and how big it is the bulb.