Want this question answered?
under the hood, right side, color brown, 15 pins, under to another relay grey
The signal wire should be Tan. You should have a Yellow, Black, and Tan Wire. The Yellow being you MAF Sensor Signal. The Black being a Low reference voltage. Then your Tan your IAT sensor signal.
under the hood, right side, color brown, 15 pins, under to another relay grey
2001 Suzuki Grand Vitara turn signal light bulb lamp replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
not sure the exact location of the wire in the harness, but i can tell you that the speed sensor has 2 wire leads, that run directly to the PCM. they are in ports 20 and 21 on the PCM wire connector. Pin 20 is for speed sensor low signal and is Light green and black in color. Pin 21 is for speed sensor high signal and is purple and white in color
you might try www.haynes.com, these are the folks that have all the manuals for wiring etc.
The black wires are the heater wires, the white wire is the signal wire and the green is the ground wire.
2000 Suzuki Grand Vitara bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. The owner's manual is the best place to start for bulb replacement. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Black for signal, Gray for ground, 2white's for heat
It is used to separate the color burst signal from the color signal.
I believe it is the black wire coming from stock o2 sensor. I have tested this wire with votmeter and have seen voltage fluctuation from 200 mv - 900mv. I think this is correct.
right by the oil filter you should see a gold color one wire sensor.