In North America the white neutral wire is never switched. This is because a split single phase secondary system is used. Opening a neutral could put two branch circuit loads in series with each other.
The colour red designates that the wire is used as a live wire. The neutral wire is identified as white in colour.
Red, Yellow and Blue for Live. Black for neutral and Green for Earthing
The live wire is brown in coulor while the earth wireis green and yellow in color and neutral wire is blue in colour. Uses of these three wire: Live wire:It's connected with fuse.It carries a voltage which drives electric current through the electrical appliances. Earth wire:It is a safety device and protect us from electric shock. Neutral wire:It offers a return path by electric current.
In a flexible cable, the brown is the "line" voltage and blue is "neutral", often tied to ground at the mains panel. In fixed cables, i.e., "behind the walls", the UK wiring standard changed in 2004, where it now MATCHES the flexible cable: brown is line, blue is neutral. Prior to that, blue, red or yellow were acceptable LINE conductor colors and black was neutral.
short circuit
Yellow
The colour red designates that the wire is used as a live wire. The neutral wire is identified as white in colour.
yes
it measures the ionization of the air.
Red goes to a switched live i.e one that is only live when the ignition is switched on. Yellow goes to a permanent live i.e one that is always live whether the ignition is n or not, like the cigarette lighter, and maintains the station configuration memory. However, a modern car should have a pre-wired Din connector and a local motor factor will have the corresponding universal adaptor for your radio; connect colour ro colour (inc speaker wires) and plug it in !
Red, Yellow and Blue for Live. Black for neutral and Green for Earthing
All depends on what country you are in, wiring standards and cable type. Industrial cable in the UK is. :- Red = Live Black = Neutral Copper wire = earth. (add Green/Yellow striped sleeve at junctions.) Domestic is:- Brown = Live Blue = neutral Green/yellow stripe = Earth Europe Black = Live Blue = Neutral Brown = Earth
No. If it's a light switch then it will have a live wire, a switched live and an earth. If it's a switched socket then it will have a live wire, a neutral and an earth. Either way the switch needs to be isolated from the mains before the switch can be disconnected.
An ordinary light switch does NOT have any neutral -- it only switches the live wire. Some installers use the white wire as a "switched" wire to the light fixture, where the power cable went to the light and a separate cable went to the switch. Technically, the white wire should have been marked with red or black tape at each end, to signify it is not neutral - it is either live or off. In that case, you would not be able to use a PIR switch because there is no neutral, which is necessary to provide power to the electronic circuit in the PIR. You would need to rewire the switch with a new power cable from the branch circuit. The you have the live and neutral wires in the outlet box, connect them to the PIR, and run the pigtailed neutral and the switched live (and pigtailed ground) to the light fixture (where you would disconnect the other power cable completely and cap the ends separately).
Australia: ANZS3000 Active= Red or Brown Neutral = Black or Light Blue Earth = Green or Green and Yellow stripe
You would find a live electric wire, with a neutral and usually also an earth wire, in any place where electricity is used. The wires are colour coded differently in different areas but in Europe live is brown, neutral is blue and earth is green/yellow.
Lethal mutations cause such a radical change that the organism cannot live with it and dies. A neutral mutation is a simple change that does not affect the organism in any way, such as a new eye colour.