Temperature can cause damage to the ignition coil. Temperature which is above 150 degrees Celsius can cause a great damage to it.
Unplugging the coil wire and not grounding it, yes that can damage the coil.
A bad coil can damage a converter. If the engine is misfiring, it will cause raw fuel to get into the converter and that can cause failure.
I'm assuming you mean an ignition coil. If that is correct, an improperly functioning ignition coil will cause the engine to have a misfire, and could lead to severe engine damage if not corrected expeditiously.
To test the ignition coil of a Kawasaki Rouser 135, you can use a multimeter to check the resistance between the primary and secondary windings. Compare the reading to the manufacturer's specifications to determine if the ignition coil is functioning correctly. You can also visually inspect the coil for any physical damage like cracks or corrosion.
The ignition coil is inside the ignition distributor.
No. The coil provides the spark and the module tells the coil when to spark.
Ignition module has a coil of wire; some types of insulating materials that protects from heat damage and transistors. Ignition regulates the spark generation in internal combustion engines.
yes this does this to stop u from doing damage to the engine
check the pick up coil on the left side cover of the engine they have a stator and a little box that's the pickup coil check if its damage or the ignition coil
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
1999 Alero how do i test ignition coil pack