Its quite simple as that it ejects the shotgun shell out of the gun after it has been fired but this depends on the type. A double or single barrel shotgun would only eject the shells when u hit the release mechanism to reveal your side of the barrel then they eject out.On any other type shot gun where u load 8 or have a clip they generally fling out the side when re-cocked or if automatic they do this automatically. Hope i helped
how much is a gauge victor ejector shotgun worth
There is a hidden groove on the bottom of the ejector spring area. While initially it seems as though you should mount the spring with the half moon facing up to match the cutout in the gun you actually put the half moon piece down in the groove on the bottom which holds the spring in place and allows it to sit flush inside the gun save the ejector portion on the end.
If you removed the bolt, you probably lost the ejector spring. A new one can be had from Numrich Gun Parts. To replace the ejector spring, remove the bolt, and take out the spring from the bottom of the receiver just behind the ejector port.
victor ejector 12 ga break action
The value of the gun depends a lot on the condition. A Columbia Arms Shotgun ejector model could be anywhere from $100 to $1,800.
== ==
Put a drop of lubricant on it then use a spent casing to push the ejector in and out to get the lubricant to the spring.
Try e-gunparts.com
Got an answer from the importers. The Ejectors are held in place by the Ejector Trips, these run vertically up and into a slot on the ejectors. On the ejector trip is a very small pip with a hole in it, underneath this hole there is a small plunger and coil spring (this keeps the ejector trip in place, not allowing the ejector trip to drop down). To remove the ejector you need to have a small pin punch that you place into the hole of the pip. The process of removing the ejector is as follows, keeping the ejector held into the barrel, insert pin punch into pip hole (depressing the plunger and coil spring), pull the ejector trip very slightly downwards. Releasing the ejector it should now slide out. When replacing the ejector all you need to do is push ejector back into barrel and at the same time push ejector trip upwards locking ejector and ejector trip in place.
Do you mean a 1932 Victor Ejector model? Do you mean a 1932 Victor Ejector model?
Best left to the factory trained techs in MO
Requires a gunsmith to look at it.