0
What does negotiation mean while discussing network protocols. give example?
Wiki User
∙ 14y ago
In cases where a connection is established, the sender, the receiver and the subnet conduct a negotiation about parameters to be used. Parameters like maximum size of the message, quality of service etc are considered. One side can make a proposal and the other can accept it, reject it or make a counter proposal.
Wiki User
∙ 15y ago
Wiki User
∙ 14y agoNegotiation has to do with getting both sides to agree on some parameters or
values to be used during the communication. Maximum packet size is one
example, but there are many others.
Add your answer:
Earn +20 pts
What function do protocols perform in network communication?
protocols used for network device.
Which protocol is not routable?
NON-ROUTABLE PROTOCOLS cannot survive being routed. Non-routable protocols presume that allcomputers they will ever communicate with are on the same network (to get them working in a routed environment, you must bridge the networks). Todays modern networks are not very tolerant of protocols that do not understand the concept of a multi-segment network and most of these protocols are dying or falling out of use.NetBEUIDLCLATDRPMOP
What are routed protocols?
Routed protocols are the best paths in a network along which to send network traffic.
An nos with a backdoor is an example of a risk associated with what?
Protocols and Software Network+ Guide to Networks pg. 580-581
Two devices on a network might have to negotiate their communications protocols through a process called?
A negotiation sequence can be done via a technique known as Hand-shaking, for a reliable protocol. It might be called other things by others depending on vernacular, etc. Usually the two devices decide on how they will exchange information on negotiation.
Is ipv6 compatible with ipv4?
IPv4 and IPv6 are two different protocols . The two protocols are not compatible with each other. But they can exist in a same network together.No, those are two different protocols. However, they can co-exist in the same network (this is known as "dual stack").No, those are two different protocols. However, they can co-exist in the same network (this is known as "dual stack").No, those are two different protocols. However, they can co-exist in the same network (this is known as "dual stack").No, those are two different protocols. However, they can co-exist in the same network (this is known as "dual stack").
What protocols do not guarantee delivery of their data but do operate with a very low overhead that conserves network bandwidth?
connectionless protocols - transport layer
What are the different wireless local area network protocols?
wide area network
What has the author Bruce Hartpence written?
Bruce Hartpence has written: 'Packet guide to core network protocols' -- subject(s): Computer network protocols, TCP/IP (Computer network protocol)
What protocols allow network to accomplish?
Tcp/ip
What does PPP use to encapsulate multiple network-layer protocols?
Network control protocol
What does protocol binding order refer to?
Protocol binding order refers to the order in which a protocol will be matched to a data packet. If, for example, you have a network connection which is running several different protocols it is important to tell the system which protocol to try first. If you are using Netware, TCP/IP, and any other protocols on the same network, if 70% of your network traffic (as an example) is TCP/IP, then you want the network operating system software to check if a packet is a TCP/IP packet first, and if not, try the other networking protocols. With the binding order, you tell the adaptor the order of checking for the correct network protocol, starting with the one with the most traffic, and going down from there.
