0
What else can I help you with?
Service ride control 2004 Yukon Denali?
Where the fuse to the ride control for yulon xl
What means this code CO251 on Yukon Denali 2004 4.8 liter engine?
yukon denali
Where is the fuel filter located on a 2004 GMC Yukon XL Denali?
Where is the fuel filter located on a 2004 GMC Yukon XL Denali? the fuel filter on a 2004 Yukon is made inside the fuel tank. Section 6 of the maintenance manual is incorrect. there is not an external filter.
What are the torque specifications for the transmission oil pan on a 2004 yukon Denali?
For a 2004 Yukon Denali, the torque specifications for the transmission oil pan bolts are typically around 10 to 12 lb-ft. It's important to follow a specific tightening sequence to ensure even pressure and avoid leaks. Always refer to the vehicle's service manual for the most accurate and detailed information.
Does your navigation map disc need to be upgraded for a 2004 Yukon Denali?
Yes, it absolutely NEEDS to be upgraded!
Where is 2004 GMC Yukon Denali starter?
on top of the starter. you have to disconnect battery then remove starter to replace it
Where is the radio amplifier location on your 2004 gmc Yukon Denali?
under the middle console between the seats
How do you turn off passager air bag 2004 Yukon XL Denali?
You cannot turn it off.
Why does your 2004 Yukon Denali show service airbag?
There is an issue with the SRS system. It could be anything from a faulty sensor to a missing airbag module. You need to have a qualified service center that is trained in troubleshooting and repairing SRS systems diagnose the problem for you.
How many gallons does a 2004 GMC Yukon Denali XL V8 6.2 liter hold?
The fuel tank capacity for the 2004 GMC Yukon Denali XL with a V8 6.2 liter engine is 31 gallons. This is for both the 2 wheel drive and 4 wheel drive versions of the car.
When should you change your fuel filter on your 2004 GMC Yukon Denali?
Every 50,000 miles or whatever your owner's manual lists.
How do you adjust parking brake on 2004 Yukon Denali?
You have to take off the caliper and rotor and adjust the brake with a flat head screwdriver
