0
What else can I help you with?
Where does the fuel filter to a 1968 Camaro go?
At the fuel inlet pipe at carb.
How can a tobacco and a marijuana pipe be used?
Load pipe with marijuana not tobacco much better for you then on the side should be a carb hold thumb over it while holding flame to marijuana and inhaling. Then release thumb from carb and remove flame however, continue to inhale and that's all you do to get high my man
How do you drain the gas from an go kart?
Usually it's easiest to detach the fuel pipe from the carb and let it drain into a container.
What is the vacuum pipe attached to on the front clip on your 82 vandura I have the pipe connected to a device that is electrical at one end and not connected at the carb end..my bacfire?
If 4 pipes of equal length measure 44 feet when they're connected together, how long is each pipe?
When accelerating my 1986 302 F250 stalls. Why?
Fuel flow! either blockage in fuel pipe or float level in carb set incorrectly.
Where is the fuel filter located on a 1985 Chevy pickup?
1985 CHEVY PICK-UP IS CARBURATED... THE FUEL FILTER IS LOCATED IN THE CARB.. BETWEEN THE FUEL FEED PIPE AND CARB. IT'S A PAPER TUBE STYE FILTER. GM# 7028281
How fast does a 400ex go with a pipe?
not fast at all only if you jet the carb, have a intake, and big bore kit recomend a 416 not no bigger than that
What would cause a car rev up and down by itself?
idle airflow metre or pipe may have come off carb check both
Why does Smoke come from exhaust pipe on riding mower?
Normally smoking is caused by piston rings wearing out, it needs an oil change, or is overfilled and sucking oil into the carb.
How do you make my ATV faster?
Get an aftermarket pipe. Different sized sprockets. Jet the carb. Get a kn air filter. Bigger tires. Big bore kit. That's it.
How do you strip a carburetor for suzuki LTZ400 ATV 2007?
Hi ya, it's pretty easy once you have done it a couple of times, first remove the side and tank plastics, undo the 2 screws holding the fuel tank in, (when you take the fuel pipe off the carb remember to clamp the pipe as the ltz doesn't have an off position on the fuel tap). You can then clearly see the carb. You then need to remove the throttle cable, I've found this easier to remove from the thumb throttle housing and leave it on the carb for the time being. It's then time to disconnect the throttle position sensor, which again disconnect from the connector rather than off the carb. Once this is disconnected it is just a case of removing the rubber boots from the carb to the air filter and to the inlet. Remember to block up the inlet with a clean rag otherwise you will have a more serious problem if anything gets dropped down there. The 2007 model doesnt have a choke cable so that makes it a bit easier. There is also an overflow pipe that is on the bottom of the carb bowl that should just pull off. When you start to dismantle the carb do it on a towel or something so if anything drops out it doesnt bounce! Happy stripping!
What is the pipe that comes from the carburetor to the exhaust manifold on a Ford Inline-6?
It might have something to do with emissions Most likely, you'll see one or two charcoal boxes, and this pipe will be part of the smog pump assembly. It shouldn't be a direct connection between the carb and the exhaust.
