all you would need is a basin with a known amount of water. put the stapler in the basin and measure the amount of water in the basin. subtract that answer by the original amount. theres the volume of your stapler.(this works for anything)
You can determine the volume of a metal stapler by measuring its length, width, and height, These figures are then multiplied together.
centimeters or inches
how
If the object, when submerged in water, displaces a volume of water whose mass is greater than its own, then it will float. The density of the material from which it is made is not the key as can be seen from the fact that ships made of metal will float.
Staples come in myriad sizes. And because of manufacturing inconsistencies, there will be some variation even within one type. As an example, Sparco standard size office staples were found to weigh approximately 32.4mg each, while Swingline Colorbright standard size staples were found to weigh approximately 33.1mg each.
Pressure developed within a volume of molten metal.
Divide the mass by the volume to calculate its density. If its density isn't the same as an equal amount of pure silver, the coin has some other metal in it.The density test can be fooled if the coin was adulterated with other metals that average out to the same density as silver, however.
The density is the ratio of mass to volume. It doesn't matter what size the piece of metal, if it is the same metal it has the same density, 8.4.
the first stapler was made of metal
Density is the mass of the object divided by its volume. By this principle, to determine the density of a metal, place the metal onto a scale to measure its mass. After this, place the metal into a beaker of water and measure the volume change in the beaker. Divide the mass by the volume and you get the density.
Steel
When you open it up you have to push the metal slide down- (that is in the top of the stapler) then click it together and use it! Put the metal slide back to normal when finished using
Not with a normal office stapler, but an industrial stapler maybe. A very powerful hit in the right spot. I am sure a nail gun could. __ A heavy duty office stapler, made of metal (and there are many, I own one) can kill a person if you hit them in the right spot. You can kill anyone if you hit them hard enough on the skull.
By a measurement of the mass and volume because: Mass=Volume/Density.
A stapler is composed of mostly aluminum sheet metal, cut and pressed to function, and plastic injection molds.
A stapler is a mechanical device that joins pages of paper or similar material by driving a thin metal staple through the sheets and folding the ends
Staplers are made of plastic and steel. The important part of the stapler, which pushes a blade through the stick of staples, has to be made of steel, for strength.Various other parts can be made of plastic, depending on the quality of the stapler.
Not every part of the stapler. Only the metal part is conducting. The top and bottom surfaces of a stapler are normally made of plastic or rubber, which are insulators. ===========================
i tapped mine lightly with a hammer and the top portion popped out and was able to open it up.
No, the volume of a metal increases as it is heated. It expands.