I would use a hot glue gun.
Rubber cement is a type of glue that is oten used in gluing paper, because it is not water-based, and therefore does not ruin the paper.Rubber glue is an elastic polymer mixed with a solvent like acetone. When it's applied, the solvent dries out allowing the glue to harden and adhere.
A magnet does not adhere to copper!
Most glue is sticky to the touch, as this is part of its function. However, various glues and adhesives may not feel sticky, and only adhere through the addition of heat (hot glue), moisture (envelopes), or pressure (glue dots).
I've never heard of anything that will adhere to candle wax. It's too greasy.
Contact cement will do the job.ANS 2 - Epoxy or silicone will also work for this.
Tite Bond 2 will work on cork to cork, but not as well as the new Elmer's Spray Contact glue.
there are sticky pads use those
Silicone will do that.
The new Elmer's Spray Glue is very good for that.
Silicone.
I would use a hot glue gun.
Polyurethane construction adhesive like Sikabond Construction Adhesive will glue cork to marble. You could also use a hot glue gun.
epoxy works for wood and metal.
it should
Cork is so porous, I don't think you can get the glue out. It will at least stain the cork. Can you replace the damaged tile?
Cork boards are made by framing a section of cork and glue it to wood or plastic. A cork board is used as bulletin board to post notes and messages.