The 6.6KV device will conduct before the 11KV device, quite possibly even in normal operation. Don't use it this way!
Craig, Please refer to Australian Standard AS3000:2007 for the answer.
switchgear is electrical equipment regulats from electricity
Because if we use a generator of 33kv or higher then the radii must be of 2-3 meters that is not good. And also the area of the generator will be very high and losses and heat paameters will also be high. The main point is that we use 11kv generator at power plants and we have to step up the power to 220KV or 500KV etc. So we use 11kv or 22kv instead of 33 kv or higher.. By doing so we save the cost of area required, radii of rotor, and losses produced by higher power generators.
It is better to check the BDV (Break down voltage) of the oil to decide whether the said oil is usable for 11KV application, instead of depending upon its "expiry" date.
The higher voltage it transformed to a lower voltage by the use of a step down transformer.
600mm is the distance between two conductors in 11kv line
Craig, Please refer to Australian Standard AS3000:2007 for the answer.
switchgear is electrical equipment regulats from electricity
4444
Because if we use a generator of 33kv or higher then the radii must be of 2-3 meters that is not good. And also the area of the generator will be very high and losses and heat paameters will also be high. The main point is that we use 11kv generator at power plants and we have to step up the power to 220KV or 500KV etc. So we use 11kv or 22kv instead of 33 kv or higher.. By doing so we save the cost of area required, radii of rotor, and losses produced by higher power generators.
if we take 11kv /33kv yhe current produced will be less when compared to 230v/11kv.. the curent produced will be gerater than 1000amp or above so the winding of the transformers will damage because thier is no winding at present to with stand the huge amount of current by K.B.N.GANGADHAR sasi institute of technology and engineering
750MVA to 1000MVA for 33kV and 350MVA for 11kV
It is better to check the BDV (Break down voltage) of the oil to decide whether the said oil is usable for 11KV application, instead of depending upon its "expiry" date.
To be precise this kind of hi voltage is called distribution by power company. 11kv 16 kv that type of voltage. however transmission can be in the range of 5ookv. And you can see at tower from interstates lines
A nice, brand new, Roland TD-11KV drum kit (with mesh heads) should cost about $1600. Used can range anywhere from $1400-$1600
A good rule of thumb is 1" per 1000V
High voltage reduces the amount of energy wasted in transmission lines.