This refers to the width of the processor. A byte has 8 bits and codes 0 to 28-1 (255). Most computers have 32 bit processors.
16bit refers to the number of bits that can be used in a single data format element. 16bit graphics are found in games that can be played on the original Nintendo Entertainment System console.
Standard VGA is 16bit.
The h-L register in computing refers to a pair of registers used in some processors to store a 16-bit memory address. It is often used for memory operations and calculations involving memory addresses. The h register stores the high-order byte while the l register stores the low-order byte of the address.
the accumulator is an 8-bit register then is part of the arithmetic/logic unit(ALU). this register is used to store to store 8-bit data and to perform arithmetic & logical operation. the result of an operation is stored in the accumulator. the accumulator is also identified as register A.
The CPU current-register-set pointer is changed to point to the set containing the new context,which takes very little time. If the context is in memory, one of the contexts in a register set must be chosen and be moved to memory, and the new context must be loaded from memory into the set. This process takes a little more time than on systems with one set of registers, depending on how a replacement victim is selected
first of all set multimeter to register section set the ohm rang as per the requirement (ohm, K ohm, or M ohm) set the both the end of multimeter wire at the both end of the register and note down the result which is displayed on the screen
bcz multiplication and division done in 16bit operation so we must ve to use pair of reg so we ve to use ax reg ....... thats why final value store in a and b pair of reg....
Its 16bit microprocessor,and-> the 8086 has a 16bit databus 20bit address bus-> the intel 8086,is designed to operate in two modes namely(1) minimum mode(2) maximum mode
An instruction is a command to the microprocessor to perform a given task on specified data. Each instruction has two parts: One is task to be performed,called the operation code (opcode). Second is the data to be operated on, called the operand. It can be specified in various ways,it may include 8bit/16bit data, an internal register, a memory location , or 8bit/16bit address. In some instructions, the operand is implicit. The 8085 instruction set is classified into three groups according to Word size. They are- 1. One word / 1 byte instructions 2. Ttwo word / 2byte instructions 3. Three word / 3byte instructions
Okay you have to go to weeworld and then it says register and you register yourself. You get to make a person and then build your house. After that you can Roam earound. You are now set to play weeworld.
churva
If the context is in memory, one of the contexts in a register set must be chosen and be moved to memory, and the new context must be loaded from memory into the set. This process's time is more time than on systems with one set of registers, depending on how a replacement target is selected.