65 nm is ~47.94 foot-pounds.
45 NM is ~33.19 foot pounds.
Torque= length x force. Lenght is the distance to an object. Force must be perpendicularly acting on the object. In your question, you did not specify neither force and length of the knob. So I cannot give you a torque value. I believe the SI unit for torque is "Nm", assuming that you calculated your torque using all SI units. Then you have to convert Nm to pounds.
180 N-m is 132.76119 foot-pounds.
102,000 newton-meters is ~75,231.34 foot pounds.
-.200 Nm
the big end bearings torque down at 55 - 65 Nm
Torque in three stages 14mm bolt: 34,61 & 88 nm. (25,45 & 65 FT.LBF) Torque 12mm bolts to 19 NM. (14FT.LBF) or go to... go to tercelonline.com the information you seek is there.
Torque (Nm)
Using the 4 step torque-turn method, tighten according to the following values: - First All to 61 Nm (45 ft. lbs.) - Second All to 88 Nm (65 ft. Lbs.) - Third All (again) to 88 Nm (65 ft. lbs.) - Fourth + 1/4 Turn. Do not use a torque wrench for this step. NOTE: Bolt torque after 1/4 turn should be over 90 ft. Lbs. in the tightening direction. 1f not, replace the bolt.
The head bolt torque specs of a 1985 3.8 Ford Ltd. is 50 to 55 ft lbs. This 65 to 71 Nm belongs to a 6-cylinder torque sequence engine.
About 65 miles.
45 NM is ~33.19 foot pounds.
Tighten the cylinder head bolts 1-8 in the sequence shown. Using the 4 step torque turn method, tighten according to the following values:Step 1: Bolts 1 - 8 to 61 Nm (45 ft. lbs.)Step 2: Bolts 1 - 8 to 88 Nm (65 ft. lbs.)Step 3: Bolts 1 - 8 (again) to 88 Nm (65 ft. lbs.)Step 4: Bolts 1 - 8 turn an additional 1/4 turn. Do not use a torque wrench for this step.NOTE: Bolt torque after 1/4 turn should be over 122 Nm (90 ft. lbs.) . If not, replace the bolt.
I happen to own this particular car and have replaced the cylinder head gasket too. First tighten all bolts is a crossing pattern (like in a tire rotation) to 61 Nm (45 ft. lbs.) Second, 88 Nm (65 ft. lbs.) Third, (again) to 88 Nm (65 ft. lbs.) Fourth, with out a torque wrench, turn each bolt 1/4 in the tightening direction. Each bolt torque after 1/4 turn should be over 90 ft. lbs. If not, replace under torqued bolts.
Newton x meter is joules. (Please note that Nm is also used for torque; in this case, it happens to have the same units, but it is unrelated to energy, and can therefore not be converted to energy units.)
25 NM25 NM
30 NM 50 NM then 90°