Jeep Grand Cherokee
Jeep Grand Cherokee Limited

What is Code p0161 on a 4.7 moto grand Cherokee 1999?

012

Top Answer
User Avatar
Wiki User
Answered
2011-01-19 11:57:42
2011-01-19 11:57:42

Trouble code P0161 means:O2 sensor heater circuit malfunction

(Bank 2 Sensor 2)

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


Trouble code P0352 means:Ignition coil B primary/secondary circuit malfunction


P0700 : transmission code present. P1792 : battery power was disconnected.


Trouble code P0161 means:O2 sensor heater circuit malfunction (Bank 2 Sensor 2)


Trouble code P0161 means:O2 sensor heater circuit malfunction (Bank 2 Sensor 2)


According to Haynes, this represents a misfire in cylinder 6.


Trouble code P1494 means: Leak detection pump pressure switch or mechanical fault


Either with a scan tool or with a 10 min. battery disconnect.


Battery has been disconnected.


Diagnostic code 43 in the 1997 Jeep Grand Cherokee refers to an issue with the distributor. This often causes the Jeep to stall at operating temperature.


What does an ABS code 12 mean for a 1996 jeep grand chekoee?


Trouble code P0505 means:Idle control system malfunction



Throttle position sensor out of range.


You need to change the downstream sensor that is after the Catalytic Converter


Trouble code P0206 means:Injector circuit malfunction-cylinder 6


You need to have checked with a scan tool.


P0161 is 02 sensor 2/2 heater performance.


Diagnostic Code 12 on a 1995 Grand Cherokee just means that your battery has been dead or disconnected within the last 50 ignition cycles.


The code p1762 in a Grand Cherokee shows possible transmission problems. Low transmission fluid could be the cause. Make sure that the fluid is full then check again.


in a jeep grand Cherokee the code 11 no distributor reference signal detected during cranking. check the circuit between the distributor and pcm code 55 means the code reading is done.. that's all the codes the pcm has to relay to you.


55 is end of message. If that is the only code you have, then there isn't a problem


page 354 355 in Link in related links.


just call the dealership and tell them what you need, the will need your VIN



Trouble code P1130 means: Fuel Rail Pressure Monitoring



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.