Start with a line, L1. Draw a line perpendicular to it, L2. Next draw a line perpendicular to L2, but not the same as L1. This last line will be parallel to L1.
If there are given two parallel line L1 and L2, and a third line L3 that is perpendicular to L1, then the line L3 must also be perpendicular to L2.
No, 277 volts is the line to neutral of a 480 volt wye three phase system. L1- N, L2 - N and L3 - N will give you 277 volts. L1 to L2. L2 to L3 and L3 to L1 will give you 480 volts.
On a circuit board the prefix 'L' marked by a component, represents and inductor. This is usually some kind of coil, providing inductance. On large electrical installations, tags marked L1, L2 and L3, would generally indicate the three phases of a three phase electrical supply. Answer The letters, as shown, normally indicate terminals to which three-phase line conductors are connected.
Suppose the ratio is R.Select a side of the first figure. Suppose its length is L1. Draw a line that is L1*R units long.At the end of the line, draw an angle congruent to that on the first figure.Suppose the second side of the first figure is L2. In the second figure, draw a line that is L2*R units long.Continue in the same way all round the figure.
A voltage of 277 is the line to neutral (ground) voltage of a 480 volt wye three phase system. L1- N, L2 - N and L3 - N will give you 277 volts. L1 to L2. L2 to L3 and L3 to L1 will give you 480 volts.
R2,x,l1,li,l2,l2,l2,x
L1,L1,L1,R1,R1,R1,R1,R1,L2,L2,L2,L2 This may not work
There is not cheat for that in san andreas,you have to mod your game in order to have that
In a three phase system the term line refers to any one the three legs that are used in the system. The termination points are L1, L2 and L3. The voltages between any three legs will be the line voltage.
R2 x l1 l1 l2 l2 l2 x
L2 = Iodine than you add 2 = Diodine