The fixed or mechanically switched reactors may be used for the absorption or generation of reactive power, the amount of reactive power produced is fixed and the response time is slow.
See the diagram linked below.
It works with two reactor coils for excitation of the field reactor coil , which in turn provides current to the field. The two reactor coils are connected in shunt and series with the output of the generator stator or armature ( from where load is connected).
sensing amplifiers and its circuit diagram
The effect of current shunt feedback in an amplifier is to The effect of current shunt feedback in an amplifier is to
A circuit diagram, or schematic, is a picture of how the components in a circuit are connected together. Using the diagram, you can perform analysis of the design. You can also use it to troubleshoot a fault in the circuit.
Shunt reactor are generally employed at the end of long transmission line. During charging of line due to ferranti effect receiving end voltage increases dangerously to control this shunt reactors are used.
A circuit diagram could be related to a closed circuit if the diagram is of a closed circuit.
The shunt should short-circuit the bell during rotary dialing, so that the bell doesn't jingle as you dial out.
The heart of a nuclear power plant is the nuclear reactor.
See the diagram linked below.
The drawing of an electrical circuit is called a circuit diagram, or schematic diagram. It is a graphical representation of the electrical components and their interconnections in a circuit. It uses standardized symbols to represent different components such as resistors, capacitors, transistors, switches, and wires. The lines connecting the symbols in the diagram indicate the flow of electrical current through the circuit. Circuit diagrams are used to design, troubleshoot, and repair electrical systems, and can be found in technical manuals, books and online resources.
A shunt reactor absorbs reactive power and increases the energy efficiency of any system. It is a small device used for power compensation in high voltage transmission lines and cable systems.
It works with two reactor coils for excitation of the field reactor coil , which in turn provides current to the field. The two reactor coils are connected in shunt and series with the output of the generator stator or armature ( from where load is connected).
sensing amplifiers and its circuit diagram
Since the current has to supplied by the feed back circuit and current would be opposed less in shunt connection hence current feedback is done using shunt connection
A
A compound generator is a type of generator that has both series and shunt field windings. The series winding adds to the main field flux, providing good starting torque and limiting voltage droop under load. The shunt winding ensures stable voltage regulation at normal load conditions by adjusting the generator terminal voltage. This combination of windings allows the generator to provide stable output voltage across a wide range of loads.