Want this question answered?
The minimum size home wiring is #14 AWG, the rating for that size wire is 15 amps.
nec article 422.11[e]
The minimum size home wiring is #14 AWG, the rating for that size wire is 15 amps.
20 amperes.
Wattage = voltage x amperage. Every appliance in North America is built to work at 120 V, so you have the voltage. The amperage rating is probably written in the microwaves manual if the wattage is not. Remember the amperage you put on a circuit can't be more that 80% of what the wiring is rated for in the branch circuit.
No Article 210 in the NEC
No, and here's why: the rating of the branch, determined by the overcurrent protection, is designed for the ampacity of the branch conductors so that they breaker trips before the conductors heat up enough to start a fire. If you put in smaller wires on the same branch, they will get MUCH hotter before the circuit breaker trips, if it ever does. For example, a 20A branch, protecting 12AWG wiring; add some 14 AWG rated for 15A. Something faults the switched leg at 18A; enough to burn out the wiring but not enough to trip the breaker. House burns down, insurance doesn't pay because of "faulty wiring" installed negligently by a person without proper training and credentials.
depend on the feature of any amplication or extension of the system applications
No. This practice is a violation of Article 210.19 (A) of the NEC. "Conductors of branch circuits supplying more than one receptacle for cord-and-plug-connected portable loads shall have an ampacity of not less than the rating of the branch circuit."
The minimum size home wiring is #14 AWG, the rating for that size wire is 15 amps.
nec article 422.11[e]
SAE rating
Yes, different amperage rating circuit breakers can have the same short circuit characteristics.
The minimum size home wiring is #14 AWG, the rating for that size wire is 15 amps.
The total allowable load in amps on a branch circuit by Code is 80 per cent of the circuit rating. Therefore, a 20 amp circuit shouldn't be loaded over 16 amps total.
20 amperes.
Wattage = voltage x amperage. Every appliance in North America is built to work at 120 V, so you have the voltage. The amperage rating is probably written in the microwaves manual if the wattage is not. Remember the amperage you put on a circuit can't be more that 80% of what the wiring is rated for in the branch circuit.