0
All modern vehicles have a VSS sensor (Vehicle Speed Sensor) attached to the transmission or an axle that generates a speed signal. This signal is used by the speedometer, cruise control, and some of the engine and transmission computers.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Can the vss sensor create a no start?
No
What is a vss sensor on a 1996 Beretta and where is it located?
A VSS sensor is the Vehicle speed sensor and it is located on the transmission. It tells the computer how fast you are going and operates the speedometer and the ABS system.
What does the VSS do in a 91 Honda Accord?
The VSS (Vehicle Speed Sensor) moniters the speed of the vehicle.
1999 Honda prelude where is the vss speed sensor located?
vss= vehicle speed sensor. try the wheel.. id say there is nothing wrong with the sensor itself.. try the wiring
What is a vss on an Acura legend?
VSS=vehicle speed sensor. That acronym is the same for all OBDII compliant vehicles
What is vss on Lincoln continental on 1997?
Vehicle Speed Sensor
Where is the speed sensor on a Subaru Forester?
The vehicle speed sensor (VSS) is on the transmission of all vehicles.
Where is the vehicle speed sensor in the 2001 Hyundai Elantra GLS?
The VSS sensor is located on the transaxle
Where is the speed sensor located on 95 contour?
The VSS is on the drivers side rear of the transmission. On some models there is a second VSS in the dashboard.
Where is the vss on a 99 Ford Explorer?
I have a 99 ranger 4x4 you might be surprised that you dont have a vss ! Instead look on your rear axel . its your abs sensor, or also called, rear speed sensor!
Where is the speedometer sensor in a 2000 civic si?
The VSS (Vehicle Speed Sensor) is located on the transmission. If the speedometer is not working, it is rarely the VSS causing the problem. I would first check fuses and the ECU
How do change speed sensor in a Chevy 2001 S-10?
Disconnect the electrical connection from VSS (Vehicle Speed Sensor), remove small bolt holding the VSS bracket in place, remove VSS by gently twisting and pulling out at the same time. Clean area and lubricate the "O" ring on the new sensor before installing it.
