It's used for clamping a buret, of course.
I can actually think of three distinct pieces of equipment that could reasonably be called a "buret clamp", and I'm not certain which of them you mean.
One of them is a pinch clamp used to clamp the outflow tube (a rubber or plastic tube from the bottom of certain types of burets).
Another one is sometimes called a tube clamp, and is a piece of hardware used to secure a glass tube of some kind (such as a buret, but also a test tube or parts of a vacuum manifold) to a metal stand or framework.
Finally, there's a specialized spring-loaded piece of hardware used specifically for burets, which holds and supports them in two places on the tube (the tube clamp clamps onto the buret in a single location on the tube).
a buret clamp is used to fasten glassware into place on a ring stand
it is used to hold the buret in the laboratory
the burette clamp is used to hold burette interaction... answered by (CARLA MARIE C. BARCENILLA)
It is used to handel the burette as the ring clamp holds the test tube
They are used to support the burette fixed in a vertical position.
The burette clamp hold the burette on the stand.
A burette clamp looks like the letter X. However, it has some so adjustable pegs on both end which are used for purposes of adjusting it.
In analytical chemistry so many experiments are to be carried out to analyse the chemical properties of solutions/substances. The accuracy of analysis depend on the accuracy of iteration. An accurate reading is possible when it is fixed at perfect vertical position. In order to hold burette in a perfect vertical position during experiment a clamp must be used.
Ann Nikki Ramos
A burette, or buret, is a uniform-bore glass tube with fine gradations and a stopcock at the bottom, used especially in laboratory procedures for accurate fluid dispensing and measurement. The buret is commonly used in titrations to measure precisely how much liquid is used.
If you have an acid in your conical flask then the base will go into the burette. The burette is used to measure the amounts of base you are adding and therefore you will be able to determine the end point which is normally determined by a colour change.
A ring clamp is used to hold a burette.
A burette clamp looks like the letter X. However, it has some so adjustable pegs on both end which are used for purposes of adjusting it.
To clamp one in to keep it right up.
In analytical chemistry so many experiments are to be carried out to analyse the chemical properties of solutions/substances. The accuracy of analysis depend on the accuracy of iteration. An accurate reading is possible when it is fixed at perfect vertical position. In order to hold burette in a perfect vertical position during experiment a clamp must be used.
Ann Nikki Ramos
This device is most commonly used to determine the concentration of a known solute in ... a light source (often an ordinary low-voltage filament lamp); anadjustable ... Beaker clamp; Clamp holder; Concentric ring tripod; Double burette clamp ...
To ensure that the actual volume of liquid delivered into the conical flask is read accurately
A burette is used to very accurately measure liquid volumes.
First remove all the solid particles from the burette using a scrubber. Then wash the burette with tap water followed by distilled water thoroughly (even the nozzle). Then wash the burette with the solution to be used in the burette.
buret stand
A Burette device is used in chemistry for dispensing measured amounts of a chemical solution. It is similar to a pipette both used in titration in analytical chemistry.
A burette, or buret, is a uniform-bore glass tube with fine gradations and a stopcock at the bottom, used especially in laboratory procedures for accurate fluid dispensing and measurement. The buret is commonly used in titrations to measure precisely how much liquid is used.