It is the metal part around the outside of the drum that is around the drum head.
the drum rim is the outside of the snare drum.
Snare drum. You hit the head of the drum and the rim simultaneaously, making a much louder and more pronounced sound.
A bass drum hoop is the outer rim of the bass drum that sandwiches the bass drum head to the actual shell of the bass drum.
Higher end electronic kits have a programmable rim on the snare. You can set this to whatever sound you want, such as a rim shot.
You can tune a bass drum by turning.the knobs to the right to tighten or left to loosen on the rim of the drum. Loosen it for a lower pitch, tighten for higher pitch.
The skin of a drum is pulled tight over the rim. This gives it some elasticity, which forces the drum stick upwards when it has been hit.
Snare drum. You hit the head of the drum and the rim simultaneaously, making a much louder and more pronounced sound.
A bass drum hoop is the outer rim of the bass drum that sandwiches the bass drum head to the actual shell of the bass drum.
Taiko spinners are done by alternating between drum and rim inputs. (If you're using a keyboard, the default controls are X/C for drum and Z/V for rim.)
Higher end electronic kits have a programmable rim on the snare. You can set this to whatever sound you want, such as a rim shot.
no you cannot rim shot on the dd502 snare it is an electronic snare and you need dual zone triggering to get rim shots the dd502 snare is single zone - the 501 snare is however dual zone
D2x0.785
Some basic car knowledge here: - the tire, the rubber donut, sits on a rim - the rim is then bolted to either a brake drum, a brake rotor or possibly a hub. You can't take a tire off the axle, as it isn't attached to it. You can take a tire off the rim, you can take a rim off a brake drum or a hub. And you can take a brake drum or a hub off an axle. Let us know which it is.
You can tune a bass drum by turning.the knobs to the right to tighten or left to loosen on the rim of the drum. Loosen it for a lower pitch, tighten for higher pitch.
it is called a rim shot
The skin of a drum is pulled tight over the rim. This gives it some elasticity, which forces the drum stick upwards when it has been hit.
Hold a small wood block at back of the rim of drum and hit it with a heavy hammer as you move the block around to each side of the drum.
The metal pieces that are mounted to the shell of the drum are called the "Mounting Lugs". The bolts that go into them are called "Tension rods". Usually there is a washer and a "Claw Hook" that the tension rod goes through which fastens to the "Hoop" or "Rim" which holds the drum head to the drum, and tunes it.