A planishing hammer is used for smoothing and shaping sheet metal.
You will need a pneumatic planishing hammer. About two and a half inches in from the out-side you need to center the hammer and go around the cymbal until it is curved up all the way around at about 45 degrees. Also to get the proper sound it will need to be a thin ride, a crash would most likely work better.
it is used to hammer stuff
A hammer is used to apply force
The Warrington Hammer is used with brads. :D
Ball been hammer is used for what
Usually a tack hammer. But a brad driver that resembles an awl may be used.
A claw hammer is used for pulling nails and is most commonly used by a carpenter or other wood workers A pien hammer is used by blacksmiths, mechanics and other metal workers.
Depending on what you are using the hammer for. If the hammer is been used to pull up a nail then yes but if its been used to hammer in a nail then no. For something to be a lever it must have a fulcrum which the curve on the hammer works as as you try to pull out a nail.
The part of a hammer that uses leverage to remove nails is the 'claw', usually located on the back of the hammer. The 'face' is the front of the hammer used to drive nails.
A rebound hammer is a non destructive hammer used to test various things such as concrete.
hammer
claw hammer