classfull netwok means all range of IPs have the same of subnetmask
classless network means there is different in subnetmask of networks
for examble i have two network connected through routers
the first network ip is 192.168.2.0 255.255.255.192
the secound network ip is 10.1.2.1.0 255.255.255.240
for more information contact me on monkez_3@hotmail.com
Classful addressing means that you are using the so-called default subnet mask, and the network addresses fit in a class A, B, or C address range. Usually this occurs on an octet boundary (multiples of 8 bits).
A classless network address means it does not use a default subnet mask, and the network portion of the address can vary, depending on how many bits are being used for the network portion of the address.
advantage : classless protocols send subnet information. This allows you to create discontagious network with any given classful network address
The difference between classful IP addressing and classless IP addressing is in selecting the number of bits used for the network ID portion of an IP address. In classful IP addressing, the network ID portion can take only the predefined number of bits 8, 16, or 24. In classless addressing, any number of bits can be assigned to the network ID.
According to this site (http://www.webopedia.com/DidYouKnow/Internet/2002/IPaddressing.asp), it is part of a class C network.
OSPF is a classless link-state routing protocol. RIP version 1 and IGRP are both classful distance vector routing protocols, EIGRP is a hybrid protocol that supports classless addressing.
A default subnet mask gives you classful addressing on octet boundaries. A non-default subnet mask implies that you are subnetting a larger network into several smaller ones.
53453456
Default Route
The idea is to use networks that are larger than a traditional (i.e., classful) network - especially, larger than a class-C network.
Depends on your subnet mask. If you are talking about a classful addressing scheme in a class B, then the network would be 172.32.0.0
advantage : classless protocols send subnet information. This allows you to create discontagious network with any given classful network address
Selecting a routing protocol. Assigning IP network numbers. Assigning network addressess to interfaces.
selecting a routing protocol assigning IP network numbers Assigning network addresses to interfaces
Boundary routers have interfaces in more than one major classful network.
It depends on your subnet mask. IP addresses begining with 170 are Class-B networks and if your using classful network boundries, then the network would be 170.3.0.0. But, its unlikely you're using classful boundries these days. The most common subnet uses a 24-bit subnet mask (255.255.255.0). It that's the case, then the network would be 170.3.24.0 There are of course other possibilites- everything depends on the subnet mask.
All interfaces in the same classful network as the configured address will be included in the RIPv1 routing process.
The difference between classful IP addressing and classless IP addressing is in selecting the number of bits used for the network ID portion of an IP address. In classful IP addressing, the network ID portion can take only the predefined number of bits 8, 16, or 24. In classless addressing, any number of bits can be assigned to the network ID.
the 1 bits