CPVC glue is specifcially formulated to glue CPVC pipe and needs a primer.
No, it will not glue it, just dry up and become flaky. You must use a proper glue for each plastic. - Yellow glue is only for ABS.
Read the instructions on the glue used.
You should scratch the surface or use a piece of sand paper on it to break the surface coating.
Chlorinated Polyvinyl Chloride (CPVC) pipes can withstand heat up to 180 degrees. A special glue is used to blond it together. PPR pipes are a made of plastic and uses no glue as it is heat-fused. PPR is a commercial product.
This is quite confusing. -If you mean "plumbers glue that has been glued to the metal pipe" as opposed to "a shower that has been glued to a metal pipe" , then it's a little easier. -Any plumbers glue, be it ABS, PVC or CPVC glue, or Transition cement can be peeled off metal pipe.In future PLEASE say what exactly you mean by "metal pipe" - copper, - galvanised, or which other metal, and please -Name your glue - Most plumbers commonly use at least 4 different glues.
- HDLPE and CPVC can be joined by using Oatey Purple Primer and CPVC cement.
Super glue will not stick to polyethylene or CPVC.
I don't understand why you'd want to do that . CPVC glue is expensive, PVC glue is cheap and glues PVC pipe better.
CPVC glue should dry for at least 2 hours before turning on water to ensure a secure and leak-free connection.
No, PVC cannot be glued to CPVC because they are made of different materials and require specific types of adhesive for bonding.
No, it will not glue it, just dry up and become flaky. You must use a proper glue for each plastic. - Yellow glue is only for ABS.
Read the instructions on the glue used.
Epoxy will glue almost all plastics with the exception of the 'slippery' ones like polypropylelen, polyethylene, PEX, CPVC, and similar.
There is no special PVC pipe. CPVC can be used for hot water applications or in my opinion just use PEX pipe.
Not a good idea if you expect it to hold any pressure. This is very slippery material (i hate to work with it) and hard to glue properly at all.
You should scratch the surface or use a piece of sand paper on it to break the surface coating.
You can, bearing in mind that it will not stand any pressure or force separating the joint.