answersLogoWhite
Toyota Camry

What is diagnostic Toyota code p0121?

12

Top Answer
User Avatar
Wiki User
2013-05-22 21:42:45
2013-05-22 21:42:45

how to diagnostic this code

1

Related Questions

User Avatar

Trouble code P0121 means:Throttle/pedal position sensor/switch A circuit range/performance problem

User Avatar

Trouble code P0121 means: Throttle Position Sensor Voltage Does Not Agree With Map Sensor

User Avatar

Trouble code P0121 means:Throttle/pedal position sensor/switch A circuit range/performance problem

User Avatar

Trouble code P0121 means:Throttle/pedal position sensor/switch A circuit range/performance problem

User Avatar

Trouble code P0121 means:Throttle/pedal position sensor/switch A circuit range/performance problem

User Avatar

Trouble code P0121 means:Throttle/pedal position sensor/switch A circuit range/performance problem

User Avatar

P0120 code is for the TPS/Throttle pedal position sensor .

User Avatar

Trouble code P0302 means:Cylinder 2 misfire detected

User Avatar

P0121 Throttle/Pedal Position Sensor A Circuit Range/Performance IvryJade writes: Yes, but how do I fix it?

User Avatar

Trouble code P0441 means: Evaporative Emission System Incorrect Purge Flow

User Avatar

P0121 = TPS Voltage Does Not Agree With MAP sensor signal. That likely means the TPS (throttle position sensor) has gotten dirty inside and is sending out an erratic voltage the computer doesn't like. The usual fix for this is to replace the TPS which is a fairly easy "one-banana" job. The TPS cannot be cleaned when it goes bad, it can only be replaced.

User Avatar

C1336 means "zero point calibration of yaw rate sensor undone."

User Avatar

its next to the battery on the side of the fuse box.. should be a little box that says diagnostic.

User Avatar

Go on the web and goggle it. (TOYOTA CODES)

User Avatar

Nasal endoscopy is a procedure, not a diagnosis, so it doesn't have a diagnostic code.

User Avatar

To reset service light on Toyota Auris one can activate the code error reader which is a diagnostic tool. You can also hold down the odometer reset button.

User Avatar

This is usually refering to a Toyota specific tool or diagnostic device

User Avatar

Diagnostic Trouble Code

User Avatar

If i remember correctly that code is a result of either running the vehicle with gas cap off or not fully tightened at least 3 clicks.

User Avatar

This code is for the transmission The Direct clutch speed sensor. Have it tested most likely it has to be replaced. Had the same problem myself and managed to fix it by replacing the sensor.

User Avatar

It's not a code ,it's the start of the diagnostic programn.codes follow ,then 55 to end code reading.

User Avatar

The Ford diagnostic code 316 is a misfire detected at engine start up.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.