Basically at noloads the current value is less so we use lpf at no loads
No, but transmission line act as a lpf
Two wattmeter method is used in a three phase sysstem to measure the true power without regard to the balance ie. It can be used to measure both balanced loads and unbalanced loads.The three phase power could be measured using single phase wattmeters in each loads of the system. But using three wattmeters is quite unnecessary as we can measure it by using only two wattmeters.The three phase power could be measued by using single phase wattmeters , haing a current coil in one line and a potential coil connected between the line and some arbitrary common junction point. If that arbitrary common point is chosen on one of the three lines, then the wattmeter connected to that line will indicate zero power because it's potential coil has no voltage across it. hence, that wattmeter may be eliminated, and the three phase power can be determined by means of only two single phase wattmeters.
Wattmeters are used for the measurement of dielectric power loss. It is also useful for the calibration of commercial forms of wattmeter and watt-hour meter in laboratories.
A single wattmeter can measure power due to one phase only. But circuit arrangements , popularly called: 1) 2-wattmeter method (requiring two wattmeters) 2)3-wattmeter method (requiring 3 wattmeters) can be used for measuring power inn 3-phase circuit. The details of these method can be found in any standard book on electrical engineering.
LPF wattmeter is used for measuring power in highly inductive circuits & UPF wattmeter is used for measure power in resistance circuit in which the power factor ranges from 0.5 to unity. Answer is given by :Er. M KUMAR YADAV
Little poo face and Ugly poo face.
UPF(Unity Power Factor) is connected as the power factor is 1. Unlike OC where quantum dynamic rules apply in SC the time space gravitational lensing takes place which is why only LPF can be used.
Unity Power Factor.
Basically at noloads the current value is less so we use lpf at no loads
UPF
utter pradesh force
LPF is Low power factor, which is used to calculate overall power in VA (voltamps) kind of like calculating overall power in watts.
UPF stands for Ultraviolet Protection Factor. It is similar to the SPF number on sunscreens, but it is used for clothing. 15-24 is Good, and 50+ is 'Ultimate'.
Upf-32276-2-0
No, but transmission line act as a lpf
High LPF levels can indicate problems with the kidneys in the casts, also known as hyaline casts. Depending on whether it is the white blood cell count that's high, or the red, is what would indicate which issue you have.