Nucleonic Density gauges send a focused beam of radiation from the source holder to a detector mounted on the opposite side of the process pipe or vessel.
As the density within the pipe increases, the energy reaching the detector progressively decreases and therefore process density can be calculated. which is calibrated to give flow rate.
It is used for abrasive or highly corrosive fluids, as it is non incisive.
Is the measured process media a liquid or a gas? Is the flow measurement occurring in a pipe or in an open channel? What is the the flow rate? How much does the flow vary? If liquid, is it clean or does it contain suspended solids or air bubbles? What accuracy is required? How much head loss by the flowmeter is permissible? Is the flow corrosive or erosive? What types of flowmeter technologies can be accommodated in the location? What types of post installation service is available in area?
Is the measured process media a liquid or a gas? Is the flow measurement occurring in a pipe or in an open channel? What is the the flow rate? How much does the flow vary? If liquid, is it clean or does it contain suspended solids or air bubbles? What accuracy is required? How much head loss by the flowmeter is permissible? Is the flow corrosive or erosive? What types of flowmeter technologies can be accommodated in the location? What types of post installation service is available in area?
An electromagnetic flow meter is a flowmeter which uses the electromagnetic technology to determine the amount of volume flow though a pipe. View the Related Links section for a link with a video about this.
A Coriolis transmitter is a component of the Coriolis flowmeter. It transmits the information gathered by the flow tube sensors. This type of flow meter is used to measure the mass flow rate and density of a fluid.
Both the doppler and transit time ultrasonic fllow meter have a cost that is relatively high in comparison with other types of pipe flow meter. ultrasonic flow meter are not recommended for primary sludge , mixed liquor,carbon sludge
Nano-Nucleonic Cyborg Summoning was created on 2005-03-08.
nucleonic
A flowmeter is an instrument that is used to designed the rate of flow for a liquid or a substance such as a gas. The measure of the substance is by the volume of its weight. A flow meter can measure many substances that otherwise would not be measurable.
The letters 'nocuclines' unscramble to spell the word nucleonics.The next longest possible word is nucleonic.
You can find an ultrasonic flowmeter several places online. You could try omega.com if you're willing to pay money for it. However, you can also always check out ebay where you may be lucky into finding a great deal.
Clarence A. Haskell has written: 'Mass flowmeter summation system'
Positive Displacement meters like piston, gear etc
usually with a flowmeter. see http://en.wikipedia.org/wiki/Flowmeter ------------------ with the absence of a flowmeter, you can do this; Take the amount of fluid, then divide it by the time it took for it to flow from one place to the other. Example; 53 seconds for 100mL of water you go ; 100 divided by 53= 1.8 mL per 1sec the flow rate = 1.8mL/1s -Paws4-
F. Markiewicz has written: 'The use of a positive displacement fluid motor as a flowmeter'
D. P. Brett has written: 'Ultrasonic flowmeter performance in pulsating flow'
Anant Suryakant Trivedi has written: 'A non-contacting ultrasonic cross correlation flowmeter for liquids'
The purpose is to determine the mass flow rate of fluid. The point is that it does not measure the volume of the unit, but the mass per unit time flowing through.