One eighth of an inch is one inch divided into eight parts. Therefore, there are eight divisions to one inch. Having grown up with inches and parts thereof, it is difficult to describe the actual distance an eighth (1/8th of an inch) occupies.
we know , inch is a unit of measurement for length . now ,according to question .
we get , 3/8 X 1 inch .
=0.375 inch which is nearly equivalent to 1 cm .
1 cm =0.39 inches .
0.150 in
Direct Conversion Formula 3.8 mm*
1 in
25.4 mm
=
0.1450 in
(1/8th inch) x (25.4 millimeters per inch) = 3.175millimeters (rounded)
There are 25.4 millimetres in one inch. Therefore, 3/8 inches is equal to 3/8 x 25.4 = 9.525 millimetres.
Which do you think is smaller - 1 or 3
9.525
on a tape mesure
34
3/4 of an inch = .75 inches.75 inches = 1.905 centimeters
wat the hell r u talking about?
0.08" is a little over 1/16", is very close to 2mm. It is also the width of 12 gauge copper electrical wire.
7/16 inch is 11.1 (11.1125) mm
Yes. Four 32nds (4/32) is the same as one 8th (1/8).
A 4th of an inch plus an 8th of an inch is 3/8 of an inch. This is the diameter of a "AA" battery.
1/8th inch is 3.175 mm
No, 1/8 is much larger.
On bankstick etc its 3/8th of a inch BSF thread.
8 of them.
0.125
Check the 8th " character " of your VIN : ( .054 inch ) for " L " and " Z " engine codes ( .044 inch ) for "3" lightning ( .044 inch ) for "M" natural gas
1/8th per inch
yes 7/8th of an inch = 0.875"
125
It is three quarters of the way from the 3 inch mark towards the 4 inch mark. Imperial rulers are normally marked in 16th of an inch with the 4th and 12th marks slightly longer and the 8th even longer. The 4th mark is ¼, the 8th mark is ½ and the 12th mark is ¾; 3.75 inches is 3¾ inches so on such a ruler it is the 12th mark to the right of the 3, and will be slightly longer than the 3 marks either side of it.
1/8th of a cubic inch