Pole discrepancy relay trips all the 3 poles instantly. when all the 3 poles of CB do not close or open simultaneously I.e. with a time delay of less than 300 ms.
It will not. This relay is a Normally Open relay construction. The contacts are closed only when power is applied to the relay coil. You must use either an SPST-NC (Single Pole Single Throw – Normally Closed) construction or an SPDT (Single Pole Double Throw) type of construction so a contact closure is presented when there is no power applied to the relay coil.
over current protection relay
When the coil in the relay needs to run off an AC signal rather than DC. The shaded pole keeps the relay from "chattering" every time the AC current crosses 0v on the sine wave.
straining coils are winding that we uses to prevent the fault operation of relay
Double pole single throw relay de-energized, with two separate sets of contacts open. Apply 24 volts to coil terminals, coil steel core magnetizes and pulls hinged armature towards it. The two contacts attached to hinged armature make contact with the two stationary contacts. The double pole relay has now two separate sets of closed contacts.
avoid that only one or two poles are open during steady state condition
Shading pole. It helps to stop the relay from chattering.
It will not. This relay is a Normally Open relay construction. The contacts are closed only when power is applied to the relay coil. You must use either an SPST-NC (Single Pole Single Throw – Normally Closed) construction or an SPDT (Single Pole Double Throw) type of construction so a contact closure is presented when there is no power applied to the relay coil.
The couple had a discrepancy with their repair bill.
over current protection relay
The discrepancy between you and me is our sex. In other words discrepancy means difference.
It is a device used to protect Electric Network and loads
Hi All answered in http://zone.ni.com/devzone/cda/tut/p/id/4782 = Relay Forms = 121 ratings | 4.61 out of 5 | Print DocumentRelays are classified by their number of poles and number of throws. The pole of a relay is the terminal common to every path. Each position that the pole can connect to is called a throw. A relay can be made of n poles and m throws. For example, a single-pole single-throw relay (SPST) has one pole and one throw, as illustrated in the following figure. A single-pole double-throw (SPDT) relay has one pole and two throws, as illustrated in the following figure: A double-pole double-throw (DPDT) relay has two poles, each with two simultaneously controlled throws, as illustrated in the following figure: Relays are then classified into forms. Relay forms are categorized by the number of poles and throws as well as the default position of the relay. Three common relay forms are: A, B, and C. Form A Form A relays are SPST with a default state of normally open. Form B Form B relays are SPST with a default state of normally closed. Form C Form C relays are SPDT and break the connection with one throw before making contact with the other (break-before-make).
No, discrepancy is singular. The plural form is discrepancies.
nobody
A relay call is technology that is used for people who are deaf, hard of hearing, speech impaired, or deafblind. Calls go to a center who then relay them thru keyboard operation.
.............................../ Pole 1 ---------------O O---------------------- | | ................................/ Pole 2 ----------------O O--------------------- | Two single throw switches mechanically joined together so that their individual poles are switched simultaneously. One throw actuates both poles. Example: that doubled air conditioner circuitbreaker. Add another position for each flapper "/ " and you have a double pole double throw. Periods .... were used to place flappers, which should connect to the O's below them. Graphical interface would be helpful. Throw = switching actions available to different circuit paths Pole = a power line connection to switch to the different paths.