Power hopefully is removed so the fire cannot get bigger.
An electrical fire is a class 'C' fire. In addition, Class 'A' is combustibles that leave an ash. (Paper, etc.) Class 'B' is flammable liquids. Class 'C' is electrical. Class 'D' is a metal fire.
Yes
Water conducts electricity and is therefore contraindicated for use on energized electrical equipment, however it is much cheaper than the chemicals that can be used on energized equipment making it more economical when water is able to be used. Similarly water should not be used on grease fires as it will spread out the grease and the fire rather than smothering it. Water if pure without contaminants does not conduct . Having stated that electrical fire can hardly be contained by water since the air itself will conduct electrons by ionization. So to contain an electrical fire a the oxygen must be removed and water will not do that.
explosion
Overloading the circuit or a device like a power strip will cause the wiring to heat up at it's weakest point and can result in fire, it can also cause insulation to melt resulting in an electrical short.
Now..... Don't use water!! Use sand ..... i think that heat is removed
Probably the insulation from the wire, if this is the train of thought that you are thinking.
fire is removed and small pieces of fire petrol are covered with the fire extinguisher.
Yes and No! Electrical fires are not really fires, the electrical sparks cause the ignition of the combustibles around it. Thos fires can have a blanket used in their extinguishment. The power source needs to be removed to stop the sparking.
An electrical fire is a class "C" fire. A Class "C" fire is actually a class "A" or "B" fire that is caused by electrical current.
The device that protects the home from the start of an electrical fire is an electrical breaker or in some older homes a fuse system.
A Class C fire extinguisher.
A class C fire is an electrical fire. A class C extinguisher is approved for electrical fires.
An electrical fire is a class 'C' fire. In addition, Class 'A' is combustibles that leave an ash. (Paper, etc.) Class 'B' is flammable liquids. Class 'C' is electrical. Class 'D' is a metal fire.
Neither a gasoline or electrical fire should be put out by water. A gasoline fire should be put out by a fire extinguisher labeled A B C. An electrical fire should first have the power switched off. Then the fire extinguisher should be used.
A non-electrical fire would be one involving combustibles or fuels but does not involve energized equipment.
This is a building code question, not an electrical code question. In my experience, switch gear rooms are protected by sprinklers just as any other room. I know that doesn't sound right, but it is what it is.