There is no way to answer without knowing the wattage rating of the 9 volt generator. A generator's wattage rating depends on the size of the wire in it, the wattage of the rectifiers if it is a DC generator, and the horse power of the engine or motor that is available to turn the generator.
Usually enamelled copper wire.
First, you will need the mini light bulb Second, you will need the crank Third, you'll need the metal lid Fourth, you will need the generator thingy Fifth, you will need a small PVC pipe Sixth, you will need a red and blue wire Last, you will need a crank Mini light bulb connected to the small PVC pipe, small PVC pipe connected to the rectangle plank, rectangle plank connected to a metal lid, metal lid connected to a crank, and crank connected to a blue and red wire. You will put the glue on the generator thingy. Put on the red wire connects to the blue wire And there! A generator
current electricity =battery , wire electro dynamics = motor , generator , speaker
The neutral of a generator should never get into a condition where is is floating. All generators have the neutral tied to the frame of the generator set. It comes this way from the manufacturer. If it is floating then someone has disconnected the neutral wire from the frame. Just reconnect the neutral to the generator frame again to stop it from floating. Larger generators should also have a ground rod connected to the generator frame for grounding purposes.
Magnets and wire.
An electrical generator works by moving a coil of wire relative to a magnetic field.
10 meters of wire
magnetic wire
Coils of wire and a magnet. When magnetic lines of force move across a wire, it causes electrons in the wire to move. Those moving electrons are electrical current. In a generator, either the magnet or the coils of wire spin.
A wire and a magnet
A generator moves a coil of wire through a magnetic field and that induces a current in the coil .
A generator moves a coil of wire through a magnetic field and that induces a current in the coil .
flash the armature or "A" post of the generator to the positive terminal of the battery using a peice of wire.
A coil of wire spins in a magnetic field
Sliders - 1995 Slide by Wire 4-16 was released on: USA: 18 January 1999
Yes, a well pump can be wired to a generator but to find out how well it will operate the pump's voltage and full load amperage must be stated.