The firing order is 18 43 65 72.
When you lift the engine lid and look at the engine, it should say "Zundfolge" 1432 I believe, all engines for the past 60-70 years have had the firing order embossed or stamped where it is readableon the block, engine case, or cylinder head. My '43 Jeep does, my '70 Ghia does, all other cars do as well.
43 2 1
Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?
the firing order is 1-6-5-4-3-2 #1 cyl is drivers side front of engine follow it to the dist. and go clockwise. this is striaght from the book. it's easy to do.
if your saying your engine is a 4.3 your have a v6 not a v8. even with that I've not seen a Chevy engine with cap in front like a ford or Chrysler product. v8 up until 96 i know for sure are 18436572 I have found that some police package cars with a 4.3 it can be a version of the LT1 motor that does have the distributor in the front. I didn't believe it till I saw one at a police auction. I do not, however, have a firing order for this six banger. I hpoe that this might at least help.
On my Astro, the firing order is located on the distributor cap- Where each plug wire goes into the cap, there is a number on the cap-find#1 go clockwise for the next number etc. That's your firing order
Owners manual, positive.
You don't need a diagram to find spark plugs on this engine. Follow the plug wires and you will find the plugs.
there isn't one.
The correct firing order is 1-8-4-3-6-5-7-2 Look at this diagram. Copy and paste into your browser. http://autorepair.about.com/library/firing_orders/bl-fo-7067.htm If you removed the distributor or turned the cap you're going to need to reset the timing. But anyways, looking at the cap from the front of the car put the wires on in order starting plug #1 just to the right of the six o'clock position. The go clockwise in the firing order 1-8-4-3-6-5-7-2
43 lbs = 19,504.4719263563 gramsType "43 lbs in grams" into your favorite search engine.
.43 is the gap
code 43 is related to the spark control system. (esc) the problem is usually the knock sensor wiring connector is defective and/or the sensor. the sensor is located in the right /passenger side of the engine block near the starter.
5x115 43 offset
There is a two step step 1 long bolts 46 lb and short bolts 43 lb step add 90 degrees
All 350 chevvvvies and some 4.3 V6.... 305 too... CR-copper resistor; 43-heat range
it might be a broken motor mount. there are two mounts located towards the bottom of the left and right side of the engine make sure you are getting spark to all cylinders. (check for Misfiring)
43 thousands of an inch
About 43 Lbs.
Yes. The base engine componants are the same. The differences are the intake and fuel delivery.
code 43 is electronic spark control open circuit.
Take it to an authorized repair center or a qualified gun smith.