Top Answer
User Avatar
Wiki User
Answered 2014-02-08 20:41:05

what is the ignition timing for a 1988 Chevy 454 engine


Your Answer

Related Questions

The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.

how to do ignition timing on 1988 Toyota corolla fx

How do i change the ignition switch in a 1988 Chevy camaro

Your engine has distributor-less ignition. The spark timing is controlled by the ECM, there is no provision for adjustment.

The 1988 Chevrolet Celebrity uses idistributorless ignition systems, the timing is controlled by the ECM. there is no provision for adjustment.

The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.

With the tan/black timing wire disconnected, with engine idling and warm, ignition timing should be set to 0 degrees.

I have a 1994 5.7 k1500, and my book says for V8 5.7 1988-1995 is TDC. (top dead center)

1988 L6: 600rpm- 4*btc with points; 8*btc HEI

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L

How do you set timing on 1988-1995 Chevy Tahoe moters 5.7l?

10 degrees BTDC ( unless engine compartment decal shows different )

Ignition timing is the primary reason. After you reset the timing. check to be sure the ignition components are working. Also check the carb. is it clean and adjusted properly? do you smell gas. Is it flooding?

www . motorcraft . com ( no spaces ) shows : Ignition timing ( 10 degrees BTDC ) for a 1988 Ford Mustang 5.0 L unless engine decal shows different

Figure out your engine type, then ask how to set timing on a 1988 corvette ***** engine. That should help you a great deal. shows the ignition timing setting , for a 1988 F-150 4.9 L ( 300 cubic inch ) straight 6 cylinder engine as 10 degrees BTDC

What kind of ignition 1988 Chevy 3500 flat bed

how do install key ignition switch 1988 Chevy s10

In a 1988 Chevy pickup the ECM is located behind the glovebox.

The ignition timing for a 1989 Geo Metro 1.0L engine is 12 degrees BTDC. (Note, first production year for the Geo Metro was 1989 rather than 1988). In 1988 Chevy did produce the Sprint model ... in which case the timing would be as follows: With 2bbl carb: 6 degrees BTDC for automatic transmission models; 10 degrees BTDC for manual trans models. With fuel injection: 12 degrees BTDC Additional info: Distributor rotation is counter-clockwise; firing order is 1-3-2

There is something not right with the engine.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.