under the ignition coils, there are one coil for each spark plug.
The 2002 Jeep Wrangler OBD 2 port is below instrument panel, left of brake pedal
Trying to replace passenger side tailight on a 2002 Jeep Liberty. Cannot disconnect the plug and the replacement connector looks different from the original! Thanks Jim
It does not exist.
No dipstick on the manual trans. You have to remove a plug at the midpoint on the side of the case to check fluid.
The sump plug/oil plug is located at the lowest point of the sump at the bottom of engine.
You buy a direct plug in kit from the Dealer.
Doesn't have one. It is a coil on plug system.
89 cherokee obd plug
For a NGK plug Part #NG7100, MFG# 7100, the stated gap is 0.04
You can, or a wrench.You can, or a wrench.
If its a new Liberty just call the Dealer or any Dodge/Chrysler Dealer for the location. On the 2002 Liberty it is in the right rear corner. You remove the plastic covering and there is the connector there where you can connect in an adapter. There is also a rubber plug in the right rear corner intended to allow you to feed the wire out without drilling a hole. You then reseal the rubber grommet with silicone sealant.
Drivers side, front to rear, 1, 3, 5 Passenger side front to rear, 2, 4, 6 Number four spark plug, top of engine, center plug of three on the passenger side.
It's .040, if not sure its on the label right under the hood
The transmission does not have a drain plug. You have to remove the oil pan to drain.
It doesn't have a drain plug. You either have to pull out of the fill hole with a vaccuum devise , or take the cover of to drain.
buy the wiring kit from parts store then just plug it in
Not in a traditional sense, the Liberty uses individual stick coils for each cylinder in the 4 cylinder and v 6.
There's an access window on the backing plate that's cover with a rubber plug.
2.4 engines ,gap is .040 and 3.7 engines, gap is .035.
The turn signal flasher relay on a 2003 jeep Liberty is in the fuse box that is below the glove compartment. Look for a large box type plug in with three prongs inside the fuse box.
AnswerGo to your local auto parts store and get a towing light kit. It will plug directly into your wire harness in the back of your jeep.