Want this question answered?
150
Don't know what the average rate is (which is why I found this post), but I just paid $135 - but that may include some travel time.
70 kcal
Flow rate of 500mL over 4 hours = 500mL/4h = 125mL/h
well average above
On average, a faucet can use about 1.5 to 2.2 gallons of water per minute when running. This can vary depending on the flow rate of the faucet and whether it is a standard faucet or a water-efficient model.
Zero, unless you needlessly leave the faucet running while you brush. In that case, it completely depends on the flow rate of your faucet.
You provide the dimensional data of the container (bath tub) but no information on the diameter of the outlet or the flow rate of the incoming water. Therefor your question is meaningless and cannot be answered.
Curious.....why would it matter? Are you talking the Aerator flow rate? These rates are stamped in the aerator. No control is required unless you were using the kitchen faucet for scientific purposes where water flow rates were crucial, or you lived somewhere where water was very scarce and the police enforced flow rates.
To know for certain, you'd need to measure your water flow from your faucet at the rate it was turned on, but if its a newer faucet, then if you have pretty good water pressure (60 psi), the faucet will only flow at 2.2 gallons per minute. Thus if you had the faucet fully open for seven hours you may have wasted as much as 92 gallons.
It depends on the type of monkey
The faucet itself does not use any water. The rate at which the water leaves the faucet is dependent on the make of the faucet.
20 days
That would be measured in any unit of volume per time unit. The natural SI unit would therefor be cubic meters per second, but liters/second are also commonly used. Note that a liter is 1/1000 of a cubic meter.
An average blood flow rate with a rested adult should be at 5000 ml/min. However, with excessive and and heavy exercise it is expected that blood flow rate through the body would increase by at least 5 or 6 times the normal amount. Cardiac output is a term described by the amount of blood pumping through a heart at a given minute.
The average flow rate of a tap is typically around 2 gallons per minute (GPM) or 7.6 liters per minute. This can vary depending on the type of tap and water pressure in the system.
Miles/ Hour A car travels 220 miles in 4 hours. What is the rate of the car in miles per hours?