Want this question answered?
If you are positive that it is asphalt I would not suggest adhering tile directly to the asphalt. If removal of asphalt is not an option I would install a subfloor and use thinset mortar to adhere the tile. Another option (probably the better option) would be to pour a concrete mix over the asphalt. Than use thinset to install the tile. The concrete will incapsolate the asphalt. Asphalt more than likely has oils in it and can be a hazard.
Asphalt roads are considered to provide the best traction for automobiles in most conditions. Concrete roads will provide better traction in high temperature areas.
The penetration point of Bitumens such as asphalt is the depth in tenths of millimeters a standard weighted needle will penetrate through a given sample of asphalt at a given time and temperature. The softening point of Bitumen such as asphalt is the temperature at which the Bitumen softens at standard conditions. Method of detrmination employs a ball and ring in which the ball falls through the ring after the softening has been reached.
Hot mix asphalt is is heated for application, which thins the material. Remember those steaming metal buckets you used to see on industrial rooftops? Cold asphalt is liquified with something else besides heat. There are two kinds: Emulsified asphalt is mixed with water and an emulsifying agent. Think of it like salad dressing that does not separate in the bottle. The other kind is called Cutback asphalt and is mixed with a petroleum solvent such as naptha, gasoline, or kerosene. They both are liquids at ambient temperature when applied; then the solvent or water evaporates, leaving the asphalt behind. Look up at asphaltinstitute.org
Liquid asphalt has a specific gravity range from 0.98 to 1.02. Typically, a specific gravity of 1.0 is used. This can vary with the type of asphalt and the temperature of the asphalt. A specific gravity of 1.0 is the same as water measured at the reference temperature of 60 degrees Fahrenheit. This specific gravity of 1.0 corresponds to a density (or specific weight) of 1 gram per cubic centimeter (1 g/cm3) or 62.4 pounds per cubic foot (62.4 lb/ft3) or 8.34 pounds per gallon (8.34 lb/gal)
To install the Asphalt Arc30 year roof depends with the materials that you will use.
If you are positive that it is asphalt I would not suggest adhering tile directly to the asphalt. If removal of asphalt is not an option I would install a subfloor and use thinset mortar to adhere the tile. Another option (probably the better option) would be to pour a concrete mix over the asphalt. Than use thinset to install the tile. The concrete will incapsolate the asphalt. Asphalt more than likely has oils in it and can be a hazard.
At high temperatures such as 275F (135C), asphalt is a Newtonian fluid. At low temperature, asphalt is a non-Newtonian fluid.
how would a temperature reading be different if the thermometer were over unshaded asphalt
form_title= Asphalt Paving form_header= Install asphalt in your home. Where are you installing asphalt?*= _ [50] Is there a certain design that needs to be paved?*= _ [50] What are the dimensions?*= _ [50]
Asphalt roads are considered to provide the best traction for automobiles in most conditions. Concrete roads will provide better traction in high temperature areas.
Asphalt.
4.2 J/g-K
asphalt has the best bounce and it doesnt make much noise
Metal roof is very expensive and not easy to install.
I usually load slow cure cutback asphalt cement between 70-75 degrees celsius for shipping.
You can lay asphalt any season as long as the air and the ground temperature are in the proper range. below a certain temp it's a definite no-no.