you probly need new pads rotors
jeck for dust on the brakes if so blow them clean with a compresor
Diod you check front brake pads
In a 2000 Ford Windstar : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A ) according to the Owner Guide
That depends what is wrong with it. The first thing to check would be the brake switch.
See sources and related links below to lookup Ford Windstar brake light lamp part numbers by vehicle year.
The 2002 Ford Windstar ECU can be found on the firewall in the engine compartment. The ECU will be on the drivers side of the firewall.
I was looking at the 2002 Ford Windstar Owner Guide and it shows : ( 5W-20 is recommended )
According to the 2002 Ford Windstar Owner Guide : ( 98.4 litres / 26.0 U.S. gallons )
To change the master cylinder on a 2002 Ford Windstar, first, ensure the vehicle is on a level surface and disconnect the negative battery terminal. Remove the brake fluid from the reservoir, then unbolt the master cylinder from the brake booster. Disconnect the brake lines carefully, and remove the old master cylinder. Install the new master cylinder by reversing the steps, ensuring to bleed the brake system to eliminate any air.
In a 2002 Ford Windstar : ( # 17 ) is a 20 amp fuse for the cigarette lighter / powerpoint and the Datalink connector
That's your LOW tire pressure warning light in a 2002 Ford Windstar
DOT ( 3 ) brake fluid
The brake warning light in a 2002 Ford Windstar can be triggered by several issues. Common causes include low brake fluid levels, a malfunctioning brake light switch, or a problem with the anti-lock braking system (ABS). Additionally, worn brake pads or issues with the brake system's hydraulic components may also activate the light. It's important to address this warning promptly, as it indicates a potential safety concern.