Unfortunately, you have not provided sufficient detail to enable HS classification fo your punch die. For example, is it hand-held? What material does it normally work on?
The more you tell me about your product, the easier it will be to determine a single HS code.
Punch Miller died in 1971.
John Punch died in 1661.
depends how hard the punch is but you can die from severe kicking
Punch Broadbent died on 1971-03-05.
Leon Punch died on 1991-12-28.
Punch Knoll died on 1960-02-08.
Punch Dickins died on 1995-08-03.
They have the same length, but the lower punch has a longer 'neck'. The lower punch never exits the die, the upper punch does.
Punch Imlach died on December 1, 1987 at the age of 69.
Whether it is blanking or piercing, size of opening in sheet is governed by punch and size of cutout piece is governed by Die. So, for piercing, Punch size should be same as required hole size and clearance should be given on Die. For e.g for a hole size Dia 8, punch size should Be 8mm and die size 8 + clearance For Blanking, DIe size should be same as size of blank and clearance should be give on punch. So for a blank of Dia 8, die size is of 8mm and punch size is 8 - clearance.
Punch Knoll died February 8, 1960, in Evansville, IN, USA.
They punch then electrical shock until you you die