4.0L engine - 8litres of "DEXTRON III/MERCON" fluid (dry fill) 2.5L engine - 6.6litres (dry fill)
Check level of transmission fluid Change transmission fluid and filter
The code p1762 in a Grand Cherokee shows possible transmission problems. Low transmission fluid could be the cause. Make sure that the fluid is full then check again.
When the fluid level is correct, either by a dipstick or a check plug.
Make sure transmission fluid level is correct Bad transmission pump?
AnswerOn my 1993 Jeep Cherokee Sport, with the AUTOMATIC transmission, I add it directly to the dipstick hole where you check the transmission fluid level. (The dipstick is near the back of the engine.) Use a funnel to add the fluid to the dipstick hole. Check the fluid level when the vehicle is at normal hot running temperature, idling in PARK. Don't overfill! It will only take about a pint (half a quart) of fluid to raise the level from "ADD" to "FULL". Add a bit at a time and recheck the level. Overfilling can cause foaming and loss of fluid.Finally, the 1993 Jeep Cherokee Sport is known to have a problem with fluid leak from the speed sensor on the transmission. So one has to add transmission fluid more frequently than normal.
You can check the transmission fluid level in your 1998 Chevrolet Corvette with the transmission fluid dipstick. The transmission fluid dipstick will have indicating marks as to the level of the transmission fluid.
You add fluid at the same place you check the fluid level. You need a special transmission funnel to do this. Be sure you use the correct fluid that Infinity recommends.
NO. You must drain it out to the correct level. To much fluid will damage the transmission before it pushes the fluid out of the vent tube.
The fluid level is checked at the transmission screw plug. The screw plug is located on the side of the transmission somewhat above the center of the body. Unscrew and remove the plug. If fluid drains out, the level is full. If it doesn't drain out, add fluid through the plug hole until the fluid is level with the bottom of the plug. Make sure you use the correct fluid.
Remove the dipstick for the transmission. Place funnel in the dipstick hole. Fill to the correct level.
Fill.
The correct fluid level is determined with the use of the dealers scan tool and the dipstick ( which is a special tool ). The scan tool is required to know internal trans temperature, That is compared to a chart and the correct fluid height can then be measured.