Want this question answered?
The RS-422 EIA-449 interface standard provides a faster data transer rate than the RS-423 EIA-449 interace standard.
ISDN BRI is a Basic Rate Interface for ISDN networks (Intergrated Services Device Network). It consists of 2 Channels: B+D. B channel is used for data and voice and consists of two 64Kbps channels=128Kbps. D channel is used for the signal and control of the interface and is 16Kbps. Together the B+D chanels are refered to as 2B+D. The maximum data rate on a BRI is therefore 128Kbps. NOTE:PRI is Primary rate Interface which uses 23x64Kbps B channel and 1x64Kbps D channel (T-1)
Bit rate interface is another name for basic rate interface, or BRI. BRI is used in ISDN configurations for voice-grade telephone operations.
SATA III doubles the maximum data transfer rate for previous Serial ATA storage interface specifications from 3 to 6 Gigabits per second (6 Gb/s),
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
Clock rate must be set on an interface that is the DCE. This provides clocking for the DTE and helps with data transmission across the connection.
It stands for Basic Rate Interface. In the Integrated Services Digital Network (ISDN), there are two levels of service: the Basic Rate Interface (BRI), intended for the home and small enterprise, and the Primary Rate Interface (PRI), for larger users.
A basic rate interface is an ISDN subscriber line which provides two B channels and one D channel.
Primary Rate Interface
It depends on the serial bit rate versus the parallel strobe cycle time but, in general, a parallel interface is faster than a serial interface. However, modern USB, Firewire, and SATA interfaces are very fast, and might be considered faster.
When the interface is functioning as a DCE device
The interface is configured as a DCE device.