0
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is Clock rate in router?
Data Generating Capability of a Device is called Clock Rate. If the clock rate is high, the processing will be slow down. If the clock rate is low, the processing will be high.
What command is used to set data speed on a router's serial port to 56 kbps?
The command is: clock rate 56000 So it will appear on the command line interface as: Router(config-if)# clock rate 56000 Reference: Networking by Jeffrey Beasley Chapter 6 page 216.
When do you need to configure a clock rate on a router interface?
When it needs to provide clocking for the serial line. This occurs when you are using a null-modem cable in a lab. You would apply the clock rate to the router that is connected as the DCE device.
What does clock rate do on packet tracer?
A clock-rate is the speed at which the Serial connection sends data to another router and each connection must match the others clock-speed or a speed mismatch error will occur. For packet tracer, the clock-rate has no effect.
Why do you need to set the clock rate on some interfaces and do not need to set the clock rate on other interfaces?
Clock rate must be set on an interface that is the DCE. This provides clocking for the DTE and helps with data transmission across the connection.
When must a router serial interface be configured with the clock rate command?
When the interface is functioning as a DCE device
What is the result of using the clock rate 56000 command at the serial interface of the router?
The interface is configured as a DCE device.
How do you set the timing on a 1993 Chevy 1500 4.3?
You need a timing light Connect to the battery and number 1 cylinder Their should be a back and a tan wire under the dash, passenger side. they need to be connected together. Set timing to 0 degrees on the tag on pulley Has a timing advance system, must be set to 0 degrees. Set by loosing lock bolt under router, plug wire cap. By turning router clock or counter clock wise until you get 0 degrees with engine running. stop engine and tighten lock bolt with out moving router. disconnect timing light and back and tan wires.
What is an IP Router?
A router that is set up to route IP packets.
In Pokémon Emerald, what is the clock set time for?
the clock is set for time
Why cant you set up your wireless router?
i got a d-link wireless router but i dont now how to set it up
How do you set clock on 2000 mountaineer?
'how do I set the clock on a 2001 mercury mountaineer'
