One is finished and the other isn't. This is very true.
The difference between lightning and static is lightning is formed by giant clouds rubbed against each other and static is something such as flanel p.j.s rubbing together. Lightning is big, and static is small.
I got the Below Answer from Allinterview.com, I just Reproduced. Bolt and nut combinations need to be "stretched" in order to provide a clamp effect across the joint. "Bolt Torquing" stretches the bolt as the nut is turned by a wrench. The more the nut is turned, the further it rides up the bolt's threads. Since it can't extend into the joint, the nut "pulls" the bolt, thus "stretching" it. "Bolt Tensioning" uses a tensioning tool to pull the bolt until the required stretch has been achieved. The nut is then turned freely by hand until it rests against the joint face. The tensioning pressure is then released. The applied stretch is retained mechanically by the nut. Since friction has an effect on how easily a nut can be turned against a joint's face when torqued, "Torquing" is much less accurate than "Tensioning" (in which friction is moot).
Bolt can be a noun, since a bolt is a type of locking mechanism. Bolt can also be a verb, like in the sentence, "Be careful, or your horse might bolt."
There is no density of a bolt
In a second class lever the fulcrum and input effort are at opposite ends with the object load between.Though with a wrench to fasten a nut/bolt you apply effort at one end and this turns the load , which to my understanding is the nut/bolt you're trying to fasten at the other end.The fulcrum is the jaw used to grip the nut/bolt and turn over and the nut/bolt is the object load.How is the load between?
the difference between a 2117 crossbow bolt and a 2216 crossbow is 99
.5 inches
Caliber, where made, bolt
you can identify the slight different between an imperial bolt and a metric bolt by looking how fine their thread pitch looks like or feels like
NPT = pipe Briggs standard = Pipe NFT and NFC and ASAE = bolt
http://holdenpaedia.oldholden.com/Block_Patterns
There is really no difference between the two. Although it seems common practice that the plummer blocks are split, with bolt on caps.
One uses 3 bolts to mount it, the other 6
The difference between a 2 bolt main and 4 bolt main is how many bolts hold the caps that hold on the crankshaft. (A 2 bolt main has 2 bolts to every cap and the 4 bolt main has 4 bolts to every cap) A 2 bolt main should be able to handle 500hp as long as you don't push it above 5500RPMs.
None. The four bolt main block is thought to be more rigid at higher loads.
A change in the breech bolt mechanism.
Usain is just a little bit faster