A time delay fuse will not blow at the first sign of an overload. It will delay blowing just long enough to allow a motor to start or a compressor to startup.
There is no difference. Slo-Blo is just a trademarked name for a time delay fuse.
we use a time delay fuse at furnace area where heaters are used ect,
The time delay fuse allows a momentary overload due to startup current.
A time delay fuse will allow for a temporary spike in the current (up to 100 or 200% of the fuse rating), such as when starting a motor. A regular (non-time delay fuse) will not allow for any spike over the current rating of the fuse. If you have a motor that pulls 2 amps while running, but pulls 6 ampls while starting, then you will want to use either a 6 amp non time delay fuse, or a 2 amp time delay fuse. If you are talking about pyrotechnics, a time delay (properly called a slow burning) fuse will give you more time to run for cover.
gG FUSES IS FAST ACTING BUT THE mA FUSES ARE TIME DELAY FUSES
Time delay fuse.
Yes, and you should use a time delay fuse.
No, use a standard fuse.
End-to-end delay is the time it takes a packet to travel across the network from source to destination. Delay jitter is the fluctuation of end-to-end delay from packet to the next packet.
time delay
A standard fuse will blow in just milliseconds when excess current flow or a short is detected. A time delay fuse on the other hand may take 5-10 seconds to blow under the same conditions. You would want to use a time delay fuse in a device that uses lots of current at startup but then uses less after it is started. An electric motor or compressor is an example.
End-to-end delay is the time it takes a packet to travel across the network from source to destination.Delay jitter is the fluctuation of end-to-end delay from packet to the next packet.