There is no difference.
The difference between pulse code modulation and delta modulation is that pulse code modulation is a method of encoding audio information digitally while delta modulation is a method that converts analog to digital signal.
space vector modulation id an algorithm of the control of the control of pulse width modulation
due to space vector modulation we can eliminate the lower order harmonics
Delta modulation is not a type of quality conversion and runs on digital-to-analog, analog-to-digital. Differential pulse code modulation has a higher quality of conversion and runs on a 1-bit data stream.
PAM-pulse Amplitude Modulation It encodes information in the amplitude of a sequence of signal pulses. PPM-Pulse Position modulation PWM-Pulse Width Modulation.It results in variation of average waveform.
It signals the difference between successive sample sizes
It is a type of Pulse modulation as in PPM the position of pulse of carrier pulse train is varied in accordance with the modulating signal.
Analog Pulse modulation is discreet in time but the formation is transmitted in continuous form. In digital pulse modulation, not only the time axis is discreet but the information is also in digital form. Examples of Analog PM are PAM and PTM i.e pulse amplitude and pulse time modulations respectively. Examples of Digital PM are PCM and PDM i.e pulse code and pulse delta modulations respectively.
delta modulation refers to the procedure of encoding and thereby transmitting only the difference between consecutive samples instead of sending each of the samples themselves. This method is useful only when the vaiation in the amplitude of the signal is small, otherwise, it leads to a phenomenon called "slope overload".Pulse code modulation is the procedure where each of the levels of an analog signal is assigned a value closest ro a quantizer level used to quantize the signal...Another method of PCM that can be confused with Delta Modulation is the D(ifferential)PCM. Here, the difference between the signals is encoded based on its magnitude..
Frequency modulation, as the name suggests, modulates the carrier by changing the frequency of the signal emitted. Pulse width modulation, changes the on-time of a square wave, but leaves the frequency of the carrier wave unchanged. So, in frequency modulation, the frequency will vary between, say, 80kHz and 120kHz with a constant power level, but in pulse width modulation, the frequency will stay at 100kHz, but the on-time (the length of each pulse) will vary, hence the power level will vary accordingly.
Explain with diagram the technique Pulse-width modulation?
Space-vector (pulse width) modulation technique is a PWM technique for three-phase voltage-source inverters. Read the white paper I linked below, or the app note that I also linked below. Interested in the real nitty gritty? Try the PhD Thesis that I linked below.